Intermec PB42 Manual

The printer shoulder strap (P/N 074788-xxx) provides you with a convenient
way to carry your PB42, PB50, or PW50 printer. The wide padded strap makes it
comfortable to wear the printer for long periods of time.
The shoulder strap kit contains these parts:
•Shoulder strap accessory
•These instructions
To attach the shoulder strap to the PB42 or PB50
1Install the handstrap on the printer.
2Orient the shoulder strap so that the textured side of the strap padding is facing
toward the printer. You want the textured side of the padding to sit on your
shoulder when the strap is installed.
3Attach the snap hooks on the ends of the shoulder strap to the D-rings on the
handstrap.
You are now ready to use the PB42 or PB50 with the shoulder strap accessory.
Printer Shoulder Strap Instructions
Handstrap
D-ring
(2 places)
Shoulder strap

Worldwide Headquarters
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel [phone]
fax [phone]
www.intermec.com
©
2008 Intermec Technologies
Corporation. All rights reserved.
Printer Shoulder Strap Instructions
*943-160-001*
P/N 943-160-001
To attach the shoulder strap to the PW50
1Orient the shoulder strap so that the textured side of the strap padding is facing
toward the printer.
2Attach the snap hooks directly to the PW50, or if you have a handstrap installed,
attach the snap hooks to the D-ring on the handstrap.
You are now ready to use the PW50 with the shoulder strap accessory.
Handstrap
D-ring