Intermec EasyCoder PF4i User manual

PF4i
Cutter Tray Installation Instructions
Use these instructions to install the tray onto the PF4i Cutter for the
EasyCoder PF4i Printer. The shipping box contains the tray, secure plate,
screws, washers and these instructions.
To install the tray
1Attach the tray to the cutter by inserting the hinges of the tray into the
slots on the cutter.
2Slide the flange at the rear of the secure plate into the slot between the
cutter and the front of the printer.
3Align the alignment pins on both sides of the secure plate to the tray.
4Insert and tighten the screws and washers to secure the tray to the secure
plate.
Tray
Secure plate
Screw
Screw
Alignment pin

Worldwide Headquarters
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel [phone]
fax [phone]
www.intermec.com
©2008 Intermec Technologies
Corporation. All rights reserved.
PF4i Cutter Tray Installation Instructions
*943-119-002*
P/N 943-119-002