International Concepts T-42DP User manual

ITEM NO.: T- 42DP
REVISED MAR 09, 2015 Printed in Vietnam
- 1 -
ASSEMBLY INSTRUCTIONS
Description
Item No.
: DROPLEAF PEDESTAL TABLE
: T-42DP

ITEM NO.: T- 42DP
REVISED MAR 09, 2015 Printed in Vietnam
- 2 -
BEFORE ASSEMBLY
Thank you for purchasing this quality product. This product has been designed for easy assembly
and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to
beginning assembly, however, make sure all parts and hardware are included and free of obvious
defect. If a part is missing or defective, please contact the store where purchased. If hardware is
missing, or you need help with assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the
parts from being scratched.
-Remove all wrapping material, including staples & packing straps before you start to
assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
WARNING:
Long exposure to rubber or soft plastic may cause a chemical reaction and damage the
finish of your table. Protect the surface of the table with cloth if you are using any product
with rubber feet or base.
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO Description Qty Sketch NO Description Qty Sketch
A Top 1 B Leg 4
C Pedestal 1
D Mounting Plate 1
E Wood slide 2

ITEM NO.: T- 42DP
REVISED MAR 09, 2015 Printed in Vietnam
- 3 -
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO Description Qty Sketch NO Description Qty Sketch
1
Large flat
washer
(8.5x19mm)
4 2
Large lock
washer
(8.5x13mm)
4
3 Hexagon nut
(M8x13mm) 4
4 Wrench
(13mm) 1
5
Small Flat
Washer
(6.5x13mm)
4 6
Small lock
washer
(6.5x11mm)
12
7
Medium flat
washer
(6.5x16mm)
8 8 Bolt
(M6x45mm) 12
9 Allen key
(4x80mm ) 1
STEP 1
Attach the legs (B) to the pedestal (C) with washers (1), and (2) and nuts (3). Tighten with the wrench
(4).

ITEM NO.: T- 42DP
REVISED MAR 09, 2015 Printed in Vietnam
- 4 -
STEP 2
Put the mounting plate (D) on top of the pedestal, and attach with bolts (8), and washers (5), and (6).
Tighten with the Allen key (9).
Insert the wood slides (E) into the groove of the mouting plate.
STEP 3
Carefully place the base (from step 2) on the bottom side of the top (A). Attach the mounting plate
to the top (A) with bolts (8), and washers (6), and (7). Tighten with the Allen key (9).
E

ITEM NO.: T- 42DP
REVISED MAR 09, 2015 Printed in Vietnam
- 5 -
STEP 4
Hold the dropleaf push and slide the wooden piece from underneath the table top . To lower the
dropleaf, carefully hold the dropleaf with one hand and slide the wooden piece from underneath
the table top towards the center of the top. Then, gently lower the leaf and place in the down
position.