International Concepts ADIRONDACK C-519 User manual

ITEM NO.: C-519
REVISED DEC 06, 2016
Printed in Vietnam
- 1 -
ASSEMBLY INSTRUCTIONS
Description
Item No.
: ADIRONDACK CHAIR
: C-519

ITEM NO.: C-519
REVISED DEC 06, 2016
Printed in Vietnam
- 2 -
BEFORE ASSEMBLY
Thank you for purchasing this quality product. This product has been designed for easy assembly
and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to
beginning assembly, however, make sure all parts and hardware are included and free of obvious
defect. If a part is missing or defective, please contact the store where purchased. If hardware is
missing, or you need help with assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the
parts from being scratched.
-Remove all wrapping material, including staples & packing straps before you start to
assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

ITEM NO.: C-519
REVISED DEC 06, 2016
Printed in Vietnam
- 3 -
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
A
Seat frame
1
B
Back frame
1
C
Cross bar
1
D
Front leg
(L-R)
2
E
Arm
(L-R)
2
F
Supporter
(L-R)
2
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
1
Long bolt
(M6 x 65mm)
2
2
Short bolt
(M6 x 35mm)
14
3
Parasgute Canopy
(M6 x 13mm)
8
4
Screw
(M4 x 15mm)
4
5
Allen key
(M4 x 30 x 120mm)
2
6
Somer’s Pointe
1
7
Nail
(10mm)
2

ITEM NO.: C-519
REVISED DEC 06, 2016
Printed in Vietnam
- 4 -
STEP 1
Attach front legs (D) to seat (A) with bolts (2) and canopies (3) and attach crossbar (C) to front legs
(D) with bolts (2) as shown below. Tighten with Allen keys (5).
STEP 2
Attach supporters (F) to the seat (A) with bolts (2) and canopies (3) and shown below. Tighten with
Allen keys (5).

ITEM NO.: C-519
REVISED DEC 06, 2016
Printed in Vietnam
- 5 -
STEP 3
Attach back (B) to the seat (A) with bolt (1) and attach back (B) to supporters (F) with bolts (2) as
shown below. Tighten with Allen key (5).
STEP 4
Attach arms (E) to supporters (F) with bolts (2) as shown below. Tighten with Allen key (5).
Attach arms (E) to the front legs (D) with screws (4) as shown below. Tighten with a screwdriver.

ITEM NO.: C-519
REVISED DEC 06, 2016
Printed in Vietnam
- 6 -
STEP 5
Attach Somer’s Pointe (6) to back frame (B) with nails (7) as shown below.