International Concepts Whitewood T-7B User manual

ITEM : T-7B Printed in Vietnam
- 1 -
Description
Item No.
: TRANSITIONAL PEDESTAL FOR SOLID TOP
: T-7B
BEFORE ASSEMBLY
Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability. Please take
the time to read and follow the assembly instructions carefully.
ASSEMBLY INSTRUCTIONS

ITEM : T-7B Printed in Vietnam
- 2 -
Be sure to check all packing material carefully for small parts which may have come loose inside the carton during shipment. Please
separate, identify, and count all parts and metal hardware. Compare with part list to be sure all parts are present.
If hardware is missing or you have difficulty assembling this product, please call Toll Free: 1-888-944-8396.
IMPORTANT NOTE:
- Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
- Remove all wrapping material, including staples & packing straps before you start to assemble.
- DO NOT tighten all screws and bolts until completely assembled.
- Keep all hardware parts out of reach of children.
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have the following
parts:
NO Description Qty Sketch NO Description Qty Sketch
A Leg 4 B Pedestal
column 1
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have all of the
following hardware:
NO Description Qty Sketch NO Description Qty Sketch
1
Flat washer
(Φ8xΦ19mm)
12 2
Lock washer
(Φ8xΦ11mm)
12
3
Hexagon nut
(M7.8x13mm)
12 4
Wrench
(M13mm)
1
5
Height
adjustable
leveler
(M6)
4 6
Allen key
(4mm)
1
STEP 1
Attach legs (A) to column (B) with nuts (3), washers (2) and (1). Tighten with wrench (4) as shown below.

ITEM : T-7B Printed in Vietnam
- 3 -
1
2
3
4
STEP 2
Detach mounting plate from a table top with Allen key (6) as shown below.
REMOVE
6
A
STEP 3
Attach the mounting plate from Step 2 to top of the column (B) with nuts (3), washers (2) and (1). Tighten with the
wrench (4).

ITEM : T-7B Printed in Vietnam
- 4 -
1
2
3
4
STEP 4
Attach the mounting plate back to the table top with bolts and washers (from Step 2). Tighten with Allen key (6).
Assemble the height adjustable levelers (5) at bottom of legs (A).
5
6