Interstuhl Büromöbel EVERY EV256 User manual

ASSEMBLY INSTRUCTIONS
EVERY EV256
STEP 1
Place the base (1) upside down and
press the five castors (2) into the five
holes. Watch out for damage to the
floor or table! For example, put a towel
underneath.
STEP 2
Place the base on the wheels and
insert the gas spring (3).
STEP 3
Turn the seat (4) upside down.
You can use the box as a handy
assembling stool.
Take the mounting kit with the
Allen key and the 2 screws (5).
STEP 4
Slide the armrest (6) into the opening.
Make sure that the lever is open
(push in as marked).
STEP 5
Page 1 of 2
Unpack the box and
sort all parts.
1
2
7
6
Also pay attention to the difference
between left and right, the armrest
must point forward. The front of the
seat is black.
STEP 6
3
4
5
8

STEP 10 STEP 11 STEP 12
Page 2 of 2
STEP 9
First, loosely tighten the screw with
the Allen key. Then fully tighten. You
will need to use some force to insert
the screw. Then close the lever.
STEP 8
For the armrests you need the
Allen key and 1 screw per side.
The screw must go in the inner hole.
STEP 7
Before assembling the backrest (8),
take the mounting kit with
the Allen key and the screws (7).
Now slide the backrest in the
opening for the back bar.
Make sure the three screw holes are
exactly under the holes.
Tighten the 3 screws only lightly at
first before tightening them all with
the Allen key.
STEP 13 STEP 14
Place the seat (4)
on the gas spring (3).
STEP 15
Your chair is ready to use!
ENJOY!
Push the seat firmly. This can also be
done by sitting on the chair.
3 years
guarantee
on fabric and
wheels
10 years
guarantee
tested safety ergonomics
approved
Quality produced
in an environ-
mentally friendly
manner
Quality
Office Schadstoff
geprüft
Blaue Engel
BIFMA
Level 3
sustainable supply
management
For questions regarding installation, please call [phone] (Mon-Fri, from 8 a.m. to 5 p.m.)