IPC CT40-55-70 BT User manual

This guide is intended for quick consultation only and does not replace the user and maintenance manual.
Before using the machine, read the user and maintenance manual contained in the machine’s packaging thoroughly and strictly follow all the
instructions.
PREPARATION & OPERATION
CT40-55-70 BT Quick guide
1
5
2 3
4
78
6
9
PLDC02179.indd
ON
CHEM
H
2
O
+

REPLACING THE SQUEEGEE BLADES
ATTACHING/REMOVING THE BRUSHES
Open the clip (Ref. 1).
Remove the two blade retainers (Ref. 2) by pushing them outwards then extracting them.
Remove the blade.
Reuse the same blade by reversing the edge in contact with the oor until all four edges are worn out, or replace with a new blade, tting it onto the
screws on the body of the squeegee.
Reposition the two blade pressing devices by centering the wider part of the slots on the squeegee body fastening pins, then push the blade pressing
devices inwards.
Close the hook again.
Replace the squeegee on its support, following the instructions described previously.
Attaching the brush: rest the brush on the oor in front of the machine and centre it with the guard. Lower the head and operate the brush/drive lever repeatedly until the brush automatically
engages on the ange hub. If the operation is not successful, repeat by pressing on the lever again and repeating the centring.
Removing the brush: raise the machine head by pushing the head lift pedal down and then to the right and operate the brush/drive lever repeatedly. After operating the lever a few times, the brush
is released and falls to the ground.
DAILY MAINTENANCE
Clean the dirty
water tank.
Check the suction lter is
undamaged and clean.
Check that the
detergent outlet lter
is clean.
Check that the brush
is clean. Replace if
necessary.
Check that the
squeegee is clean
and the blades are not
worn.
PLDC02179.indd
1
2
BATTERY CHARGER ON BOARD
24V
BATTERY CHARGER STAND ALONE