REPLACING THE SQUEEGEE BLADES
ATTACHING/REMOVING THE BRUSHES
Open the clip (Ref. 1).
Remove the two blade retainers (Ref. 2) by pushing them outwards then extracting them.
Remove the blade.
screws on the body of the squeegee.
Reposition the two blade pressing devices by centering the wider part of the slots on the squeegee body fastening pins, then push the blade pressing
devices inwards.
Close the hook again.
Replace the squeegee on its support, following the instructions described previously.
Removing the brush: raise the machine head by pushing the head lift pedal down and then to the right and operate the brush/drive lever repeatedly. After operating the lever a few times, the brush
is released and falls to the ground.
DAILY MAINTENANCE
Clean the dirty
water tank. undamaged and clean.
Check that the
is clean.
Check that the brush
is clean. Replace if
necessary.
Check that the
squeegee is clean
and the blades are not
worn.
PLDC02179
BATTERY CHARGER ON BOARD BATTERY CHARGER STAND ALONE
