IRiver MPlayer User manual

User Guide

CONTENTS
Components 4
Locating the Controls 5
Installing iriver plus 3 6
Installing Windows Media Player 11 7
Chapter 1
Getting Started
Music 20
Chapter 3
Using the Mplayer
Charging the Battery 10
Turning on / off the Player 11
Playing Music Files 12
Connecting Products 13
Chapter 2
Basic Operations
Using iriver plus 3 26
Using Windows Media Player 11 30
Copyrights / Certication /
Trademarks / Limited Liability 33
Safety Instructions 34
Troubleshooting 36
Chapter 4
Other Information

CONTENTS
Chapter 1
Getting Started
Components 4
Locating the Controls 5
Installing iriver plus 3 6
Installing Windows Media
Player 11 7

4
Chapter1 Getting Started
Components Components are subject to change without notice and may vary from images shown.
Mplayer Earphones
Quick Start Guide & Warranty Card Installation CD USB Cable

5
Chapter1 Getting Started
Locating the Controls
Necklace Connection Loop
Earphones Jack
LED
USB Jack
POWER Button
RESET Button

6
Chapter1 Getting Started
1. Insert the installation CD to your PC to display
the installation process screen.
2. Click [Install] and complete the installation process
following the on-screen instructions.
Note
Minimum requirements for using iriver plus 3
Intel® Pentium®ll 233MHz or higher processor speed Windows 2000/XP 64MB or above memory
30MB or above hard disk space 16bit enabled speaker and sound card
Microsoft Internet Explorer version 6.0 or later SVGA or high resolution monitor (1024x768 resolution or higher)
For more information on using iriver plus 3, refer to page 26~29.
Installing iriver plus 3 iriver plus 3 is an integrated software that efciently manages music les.
iriver plus 3 gives you freedom to transfer music les from PC to the player.

7
Chapter1 Getting Started
1. Insert the installation CD to your PC to display
the installation process screen.
2. Select Windows Media Player 11 and click the
[Install] button.
Complete the installation process following the
on-screen instructions.
Note
Minimum requirements for using Windows Media Player 11
Windows® Vista
Intel® Pentium® ll 800MHz or higher processor speed 512 MB or greater memory 20GB or greater hard disk space
16-bit enabled speaker and sound card Microsoft Internet Explorer version 6.0 or later
SVGA or high resolution monitor (1024x768 resolution or greater)
For more information on Windows Media Player 11 , refer to pages 30~32.
Installing Windows Media Player 11

CONTENTS
Chapter 2
Basic Operations
Charging the Battery 10
Turning on / off the Player 11
Playing Music Files 12
Connecting Products
Connecting earphones to the Mplayer 13
Connecting earphones while playing music 13
Connecting necklace 14
Disconnecting extension earphones from main line 14
Connecting the Mplayer to your PC 15
Copying le/folder (Using as a removable disk) 16
Disconnecting the Mplayer from your PC 17

10
1. Press the [ ] button on the product to turn it on.
Note
It is recommended to use provided USB cable only. Otherwise, the device may malfunction.
Check if the Mplayer is connected to a high-power USB 2.0 port. Some low-power USB ports built in some peripheral
devices such as certain keyboards and USD hub without integrated power may not provide enough power to charge.
If the computer is in sleep mode, the Mplayer may not be charged in some computers.
The battery will be 80-percent charged in about 1.5 hour (with red LED), and fully charged within about 2.5 hours (with green LED).
You cannot play music while charging the product.
Chapter2 Basic Operations
Charging the Battery
2. Turn on your PC and connect the Mplayer to it
using the USB cable.

11
Chapter2 Basic Operations
1. Press the [ ] button to turn on the product.
You will hear a beep with green LED.
2. Press the [ ] button again to turn off the product.
You will hear a beep with red LED.
Note
If the Mplayer does not respond when pressing the [ ] button, check to see if the battery is properly charged.
If remaining battery power is not sufcient, the power will be automatically turned off after 3 beeps.
Turning on / off the Player

12
1. Press the [ ] button to play music le.
You will hear a beep with green LED.
Chapter2 Basic Operations
Playing Music Files
Note
Music playback will be resumed when you turn the product off and on again while listening to music.

13
Chapter2 Basic Operations
1. Connect the earphones to the jack of the product.
Note
To use the ‘automatic playback resuming’ function, you need to
reconnect the earphones within 1 minutes after disconnection.
After 1 minutes, the product will be automatically turned off.
Connecting Products
Connecting earphones to the Mplayer
1. If you disconnect the earphones while listening to
music, music playback will be stopped and key
input will be disabled.
However, the [ ] button will be still enabled.
2. Reconnect the earphones to resume music
playback.
Connecting earphones while playing music

14
1. Twist the detachable part of necklace to separate
it into two pieces.
Chapter2 Basic Operations
Connecting Products
Connecting necklace
1. Twist the detachable part of earphones to separate
it into two pieces.
Disconnecting extension earphones from main line
2. Hold the separated part of necklace and push it
into the direction of arrow.

15
Chapter2 Basic Operations
1. Press the [ ] button on the product to turn it on.
Connecting Products
Connecting the Mplayer to your PC
2. Turn on your PC and connect the Mplayer to it
using the USB cable.

16
Copying le/folder to the product
1. Select the le / folder in your PC and drag & drop
it to the drive which appears as a product.
Chapter2 Basic Operations
Connecting Products
Copying le / folder (Using as a removable disk)
Deleting le/folder from the product
1. After selecting the le / folder, click it with the right
mouse button and select [Delete].
2. Click [Yes] in the [Conrm File Delete / Conrm Folder
Delete] popup window to delete the le / folder.
Note
Always properly connect the USB cable.
While transferring data using the USB cable, the red LED will be ashed.
Do not turn off the product or disconnect the USB cable to protect your data from damage.

17
Chapter2 Basic Operations
1. Click the icon on the taskbar to disconnect the
product using the “Safely Remove Hardware” menu.
Connecting Products
Disconnecting the Mplayer from your PC
2. Click the [Stop] button to conrm disconnection.
Note
The icon on the taskbar might be hidden in some operating systems such and Windows XP.
Click “Show hidden icons” to display the hidden icon.
The “Safely Remove Hardware” may not be available while using some applications such as Windows Explorer or
Windows Media Player. Close all applications rst before performing the “Safely Remove Hardware”.
If the “Safely Remove Hardware” is not performed properly, try it again after a few minutes.

CONTENTS
Chapter 3
Using the Mplayer
Music
Playing Music Files 20
Listening to Music 21
Selecting additional functions 22