J D Williams Marbury 4 Seat Cube Dining Set-Table User manual

IMPORTANT, RETAIN FOR FUTURE REFERENCE
READ CAREFULLY
Marbury 4 Seat Cube Dining Set-Table
Assembly Instructions
1/5
Product size: Dia.119xH72cm

Marbury 4 Seat Cube Dining Set-Table
Assembly Instructions
Before you start
IMPORTANT, RETAIN FOR FUTURE REFERENCE
READ CAREFULLY
Warnings
Dos
See enclosed instructions for assembly, safety and care
information
Failure to follow the warnings could result in serious
injury.
Handle heavy parts with care.
Ensure that this product is fully assembled as illustrated
before use.
This product should only be used on firm, level ground.
Keep small parts out of reach of children.
Do not stand or climb onto this product.
This product is intended for domestic use only.
Furniture can be dangerous if incorrectly used. NO
liability will be accepted for damage or injury caused by
incorrect use of this product.
Do not use scourer, abrasives, washing powders,
chemical cleaners or any other substances containing
abrasives since these substances can damage the
product, including the glass panel.
Never tilt the table during use.
Do not place very hot or very cold items on the glass
surface unless adequately thick table-mats are used to
prevent such items from coming into contact with the
glass.
Do not use the glass as a chopping surface. Do not
strike glass with hard or pointed items.
Do not strike the glass with hard or pointed items.
Do not use power tools to construct this product.
Do not use this product if parts are missing, damaged
or worn.
Do not sit or lean on the table.
Do not stand or climb onto the product and do not use
it as a ladder, as this could lead to it unbalancing and
overturning.
Never drag furniture when moving it, always lift it.
Number of people required for assembly.
When you are ready to start, make sure that you have the right
tool s, plenty of space and a clean, dry area for assembly.
Remove all packaging and banding and place the components
Check the pack and make sure you have all of the parts listed.
Check all screws and bolts are tightened and inspect regularly.
This product is suitable for all year outdoor use.
We recommended the use of furniture covers to protect your
furniture when not in use. During severe weather conditions,
please move your furniture inside.
To prolong the life of the product we recommend that during
severely bad weather and during the winter months, it is stored
in a cool, dry place.
Before storage, ensure that the product is clean and dry.
To clean, wipe down with a sponge and warm soapy water and
wipe with a clean, dry cloth.
Dos
Two people
20 minutes
Time to assemble
Tools required
Tips:
Do Not fully tighten bolts before all compo-
nents are connected.
Only fully tighten once you are satisfied with
the alignment of all components.
Do not overtighten bolts.
carefully on suitable surfaces to prevent damaging or
scratching them.
2/5

Assembly Instructions
Components，fixtures & fittings （not actual size）
Parts List
Marbury 4 Seat Cube Dining Set-Table
3/5
A
Part
No. Diagram Qty Part No. Diagram Qty
F
G
H
B
C
D
E
1 PC 1 PC
4 PCS
2 PCS
2 PCS 8 PCS
1 PC
1 PC
I
J
12 PCS
1 PC
M6x15mm
M6x32mm
M6

Assembly Instructions
Marbury 4 Seat Cube Dining Set-Table
Note: All Bolt Head Caps and Nut Caps should not be attached before finally
tightening all Bolts with the Allen Key.
Only tighten all bolts when you are satisfied with the alignment of all components.
PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Step One
Put the the table top (Part A) on the ground, connect the table leg (Part C) with
the table top. Fasten table leg (Part C) with table top (Part A) by bolts (Part G)
and washers (Part I).
A
C
IG
Step Two H
B
I
Fasten table leg (Part B) with
table leg (Part C) by bolts (Part H)
and washers (Part I). Please ensure
the screws are tightend completely.
B
4/5
I
GC

Assembly Instructions
Marbury 4 Seat Cube Dining Set-Table
PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Step Three
Put the the table glass (Part E) on the table top.
E
Step Four
Put the the turntable (Part D)
on the table glass.
Step Five
Put the the small glass (Part F)
on the turntable.
D
F
5/5