J D Williams Kempton Coffee Set User manual

IMPORTANT, RETAIN FOR FUTURE REFERENCE
READ CAREFULLY
Kempton Coffee Set
Assembly Instructions
1/10
Product size: coffee table: W95xD50xH42CM
chair: W73xD68xH81CM
2 seat sofa: W131xD68xH81CM

Kempton Coffee Set
Assembly Instructions
Before you start
IMPORTANT, RETAIN FOR FUTURE REFERENCE
READ CAREFULLY
Warnings
Dos
See enclosed instructions for assembly, safety and care
information
Failure to follow the warnings could result in serious
injury.
Handle heavy parts with care.
Ensure that this product is fully assembled as illustrated
before use.
This product should only be used on firm, level ground.
Keep small parts out of reach of children.
Do not stand or climb onto this product.
This product is intended for domestic use only.
Furniture can be dangerous if incorrectly used. No
liability will be accepted for damage or injury caused by
incorrect use of this product.
Do not use scourer, abrasives, washing powders,
chemical cleaners or any other substances containing
abrasives since these substances can damage the
product, including the glass panel.
Never tilt the chair or table during use.
Do not use power tools to construct this product.
Do not use this product if parts are missing, damaged
or worn.
Do not sit or lean on the table. Do not stand or climb
onto the product and do not use it as a ladder, as this
could lead to it unbalancing and overturning.
Never drag furniture when moving it, always lift it.
Number of people required for assembly.
Dos
50 minutes
Time to assemble
Tools required
Tips:
Do Not fully tighten bolts before all
components are connected.
Only fully tighten once you are satisfied
with the alignment of all components.
Do not overtighten bolts.
When you are ready to start, make sure that you have the
right tools, plenty of space and a clean, dry area for assembly .
Remove all packaging and banding and place the components
carefully on suitable surfaces to prevent damaging or
scratching them.
Check the pack and make sure you have all of the parts listed.
Check all screws and bolts are tightened and inspect regularly.
We recommend the use of furniture covers to protect your
product when not in use.
Two people
This product is suitable for all year outdoor use. Cushions
should not be left out in wet weather or overnight.
PLEASE NOTE all cushions should always be stored indoors
after use. THE CUSHIONS ARE NOT WATERPROOF.
We recommended the use of furniture covers to protect your
furniture when not in use. During severe weather conditions,
please move your furniture inside.
To prolong the life of the product we recommend that during
severely bad weather and during the winter months, it is stored
in a cool, dry place.
Before storage, ensure that the product is clean and dry.
To clean, wipe down with a sponge and warm soapy water and
wipe with a clean, dry cloth.
Cushions should be cleaned following the care instruction
on the label.
2/10
Do not place very hot or very cold items on the glass
surface unless adequately thick table-mats are used to
prevent such items from coming into contact with the
glass.
Do not use the glass as a chopping surface. Do not
strike glass with hard or pointed items.
Do not strike the glass with hard or pointed items.

Assembly Instructions
Components，fixtures & fittings （not actual size）
Parts List
Kempton Coffee Set
3/10
A
Part
No. Diagram Qty Part No. Diagram Qty
D
B
C
E
I
2 PCS
2 PCS
2 PCS 1 PC
1 PC
2 PCS
F2 PCS
1 PC
G
H
J1
J2
K
1 PC
1 PC
3 PCS
3 PCS

Assembly Instructions
Components，fixtures & fittings （not actual size）
Parts List
Kempton Coffee Set
4/10
L
Part
No. Diagram Qty Part No. Diagram Qty
O
P
Q
M
N
20 PCS
12 PCS
1 PC32 PCS
1 PC
2 PCS
M6x25mm
M6x30mm
M6
R
M6x15mm
16 PCS

Assembly Instructions
Kempton Coffee Set
PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
5/10
Note: All Bolt Head Caps and Nut Caps should not be attached before finally
tightening all Bolts with the Allen Key.
Only tighten all bolts when you are satisfied with the alignment of all components.
Step One
Connect the table leg part (Part A)
with the side part (Part B), fasten
them by bolts (Part L) and washers
(Part N).
A
B
L
N
Step Two
Connect the other table leg part (Part A)
with the side part (Part B), fasten
them by bolts (Part L) and washers
(Part N).
A
L
N
Step Three
Connect another table side part
(Part B) with the leg part, fasten
them by bolts (Part L) and
washers (Part N).
B
L
N
How to ... assemble the coffee table