Jabra Pro 920 Mono User manual

How do I connect my Jabra wireless headset with the Jabra
Link 14201-35 to my Avaya desk phone so I have remote call
control using my headset?
Jabra Pro 920 Mono
Connection:
1. Disconnect the network cable of the phone.
2. Connect the AC adapter that is supplied with the headset to the
headset base. Connect the other end to an electrical outlet.
3. Connect the modular plug cable that is supplied with the headset to the
Jabra Link 14201-35 EHS adapter in the socket marked with a phone
icon. Connect the cable end with the blue band to the headset base
socket that is marked with a phone icon.
4. Connect the Jabra Link 14201-35 EHS adapter cable end with the white
band to the Jabra Link 14201-35 EHS adapter port marked with a white
handset/headset icon. Connect the other end to the headset interface
on the Avaya phone.
5. Connect the Jabra Link 14201-35 EHS 2.5 mm ring sensor to the Jabra
Link 14201-35 EHS adapter in the bell socket. Position the circular ring
sensor over the speaker of the desk phone.
6. Connect the Jabra Link 14201-35 EHS cable with the red band to the
AUX interface on the headset base. Connect the other end to the AUX
interface on the Jabra Link 14201-35 EHS.
05/04/2021 09:29
https://www.jabra.com.au/supportpages/jabra-pro-920/920-25-508-103/faq/3dd31ea1-
f6a5-4a3a-8b94-8a252b4b6e80
Page 1 of 2

Configuration:
1. Ensure the EHS headset function on the desk phone is enabled.
2. Follow the setup instructions for your Jabra wireless headset. If the
headset base requires manual configuration, set the electronic hook
switch setting to “DHSG” and set the dial tone switch to position “A”.
3. Make a call to the headset. If the volume of your voice is too loud or
quiet to the person you are calling, adjust the headset microphone
volume until you achieve the optimum level.
05/04/2021 09:29
https://www.jabra.com.au/supportpages/jabra-pro-920/920-25-508-103/faq/3dd31ea1-
f6a5-4a3a-8b94-8a252b4b6e80
Page 2 of 2