This devicecomplies with Part 15 of the FCC Rules /Industry Canadalicence-exempt
RSS standard(s).Operation is subject to the following two conditions: (1) this device
may not causeharmful interference, and (2) this devicemust accept any interference
received,including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produiredebrouillage,et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectriquesubi, même si lebrouillage est
susceptible d'en compromettre le fonctionnement.
Changes or modifications not expressly approved by the party
responsibleforcompliance could void the user's authority to operatethe
equipment.
This equipment has beentested and found to comply with thelimits for
a Class B digital device, pursuant to part 15of theFCC Rules. These
limits are designed to provide reasonableprotection against harmful
interference inaresidential installation. This equipment generates
uses and can radiate radio frequency energy and,if not installed and
used in accordance withtheinstructions, may causeharmful interference
to radio communications. However, there is no guarantee that interference
will not occur ina particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
to try to correct the interference by one or more of thefollowing
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
to whichthe receiveris connected.
—Consult the dealer oran experienced radio/TV technician for help.
To satisfy FCC / IC RF exposure requirements, a separation distance of 20 cm or
more should be maintained between the antenna of this device and persons during
device operation.
To ensure compliance, operations at closer than this distance is not recommended.
Les antennes installées doivent être situées de facon à ce que la population ne puisse
y être exposée à une distance de moin de 20 cm. Installer les antennes de facon à ce
que le personnel ne puisse approcher à 20 cm ou moins de la position centrale de l’
antenne.
La FCC des éltats-unis stipule que cet appareil doit être en tout temps éloigné d’au
moins 20 cm des personnes pendant son functionnement.
