Jason.L Blackjack Executive Office Desk User manual

ASSEMBLY INSTRUCTIONS
Blackjack Executive
Office Desk
Page 1 of 4
Need help!
Call us on
1300 527 665
www.jasonl.com.au
Tools Required: Power screwdriver.
2 persons required for installation
Special Note: No pre-drilled holes or nut inserts are
provided. Wood screws will be required to be drilled
directly into underside of desk top.

7
6
2
10
5
9
4
12
3
11
1
8
13
1
2
3
4
5
6
7
8
9
10
11
12
13
COMPONENTS
SCREWS
Page 2 of 4
Upper Wrist x2
Top Rail x1
Leg Tube x2
Fixed Foot x2
Foot Glide x4
Top Rail Cap x2
Plastic Support x1
Table Top x1
M10x30mm x2
M10x65mm x2
M4x20mm Self Tapping x2
M5x25mm Self Tapping x8
M8x16mm x4
ASSEMBLY INSTRUCTIONS
Blackjack Executive
Office Desk
Need help!
Call us on
1300 527 665
www.jasonl.com.au

Page 3 of 4
ASSEMBLY INSTRUCTIONS
Blackjack Executive
Office Desk
Need help!
Call us on
1300 527 665
www.jasonl.com.au
01
03 04
02
Screw the glides into the base of the fixed feet, leaving the glides one
turn from tight (then they can be adjusted easily if the floor is uneven).
Place the leg tube on top of the fixed foot, making sure each small
notch in the bottom of the leg tube is in-line with the bumps on the top
of the fixed foot. Fully tighten to maximum tension the large M10x65mm
bolts with spring and flat washer.
Place the upper wrist on top of the leg tube, making sure each small
notch in the top of the leg tube is in-line with the bumps on the bottom of
the upper wrist. Fully tighten to maximum tension the M10x30mm bolts.
With the legs assembled, place each end of the top rail into the holes
on the side of the upper wrist, making sure they stop before going all
the way through.

Page 4 of 4
ASSEMBLY INSTRUCTIONS
Blackjack Executive
Office Desk
Need help!
Call us on
1300 527 665
www.jasonl.com.au
Fully tighten the small screws located at the bottom of each upper wrist
to firmly hold the top rail in place.
Place the top rail cap into the exposed side of the upper wrist.
Locate the plastic support bracket over the centre of the top rail,
and click into place.
With the frame assembly complete, locate it in the centre of the work
surface and screw the remaining self tapping screws into each upper
wrist and plastic support.
05
07 08
06