John Lewis Asuka User manual

Asuka mirror
Thank you for purchasing this Asuka mirror. P ease read the instructions carefu y before use to ensure safe and
satisfactory operation of this product.
Pre-assembly preparation
P ease ensure instructions are read in fu before attempting to assemb e this product
Necessary Tools
This item is HEAVY
P ease check the pack contents before attempting to assemb e this product. A fu check ist of components is
given in this eaf et. If any components are missing, p ease contact the retai er from whom you bought this
product.
This product is HEAVY, it shou d be assemb ed as near as possib e to the point of use. TAKE CA E WHEN
LIFTING to avoid persona injury and (or) damage to the product.
This product takes approximate y 20 MINUTES to assemb e with 2 PEOPLE.
The fittings pack contains SMALL ITEMS which shou d be KEPT AWAY F OM YOUNG
CHILD EN.
Stock numbers 803/13908

Fittings and parts checklist
1 Mirror and back upright, 1 and 2 4 She f support pins x 12
2 She ves x 5 3 - 7 5
Screws for she f
supports x 12 (B)
3 Screws for frame x 14 (A) 6 Wedges x 2

1. Lay the mirror and back frame on their sides and attach the top shelf, 3, using 8 of the longer screws (A)
as shown below.
2. Then attach the bottom shelf, 7, using the remaining 6 screws (A).
Step by step instructions

3. Push the shelf supports (C) into the frames 1 and 2, then screw the shelves in place using all 12 of
the shorter screws (B) See below.

Fig.1 Fig.2 Fig.3
5. If after placing the mirror in its final position it is not standing level. Use the wedges (6) provided.
Push a wedge under the back leg of our mirror until it becomes level, fig.1 then snap it off as shown in
fig.2. Finally tap the wedge if it is still protruding out from under the leg, fig.3.
4. Carefully lift the mirror upright and place in its final position.

Wood Furniture
Wood displays different grain patterns depending on which way it is cut - for example, the ‘medullary ray’
which can appear on oak furniture is a mark of good quality timber - these are just characteristics of the
natural beauty of the wood. Some furniture is also deliberately aged and rustic.
All timber surfaces will change colour and mellow over time. New furniture will initially vary in shade from
items that have been previously purchased.
PLEASE KEEP THESE INST UCTIONS FO FUTU E EFE ENCE
John Lewis Partnership 171 Victoria Street London SW1E 5NN
www.johnlewis.com
Care and Maintenance
How to care for your wood furniture
Furniture with a hard lacquer, wax polish or painted surface should be dusted with a dry cloth.
When using the surface for serving food and drinks it is best to use protective mats and coasters. Spillages
should be wiped up as soon as possible.
Spray polishes are best avoided as they contain silicones which may spoil the furniture’s surface by building
up over time. Use of cleaning materials containing abrasive compounds, acidic or caustic reagents and any
bleaches containing oxidising reagents should be avoided as prolonged use may damage the lacquer surface.
Wipe up spills immediately. If sticky marks occur on the surface they can be removed with a dilute solution
of warm soapy water. The offending area should be rubbed lightly and then completely dried immediately
afterwards, before replacing any mats etc.
Our furniture will endure most temperatures in the home but it is best to avoid placing furniture next to
heat sources such as radiators or fires. Be particularly careful with solid wood as the lack of humidity
caused by central heating can cause damage such as warping.
Safety Instructions
Never drag furniture when moving it, always lift it. Please take care when handling or moving the furniture as
careless handling may cause damage or injury. No liability will be accepted for damage or injury caused by
incorrectly installed furniture.
Warning:
a) Do not place ver hot or ver cold items on the glass surfaces unless adequatel thick table mats are
used to prevent such items from coming into contact with the glass.
b) Do not sit or stand upon the glass surfaces
c) Do not use the glass as a chopping surface. Do not strike the glass with hard or pointed items.
d) When cleaning glass panels use a damp cloth or leather with washing up liquid or soft soap if necessar ;
do not use washing powders or an substances containing abrasives since these substances scratch glass.
e) Do not sit or stand on horizontal glass surfaces. The maximum load for the glass shelves is 22.9kg.