John Lewis Fawley Headboard User manual

Step By Step Assembly Instructions
PRE-ASSEMBLY PREPARATION
Please check the pack contents before attempting to assemble this product. A full checklist of
components is given in this leaflet. If any components are missing, please contact your nearest
stockist.
This product takes approximately 10 MINUTES to assemble with 2 People.
The fittings pack contains SMALL ITEMS which should be KEPT AWAY FROM YOUNG
CHILDREN.
Read this leaflet in full before commencing assembly.
Important Safety Note
Always lift the unit from the base when moving it, do not drag along the ground. It is
recommended that two people should move the unit. Never move it alone.
JOHN LEWIS FAWLEY HEADBOARD
Double and King Size

Place the wooded struts over the corresponding holes in the headboard, insert Screw
M6 x 30mm (A) into the Spring Washer M6 (B) and screw into place using Allen Key (C).
The headboard can now be attached to the Divan with the large headed screws sup-
plied by your bed manufacturer. The height of the headboard can be adjusted by
moving it up or down on the slots, tighten the screws when the headboard is in the
desired position.

Care and Maintenance
This Fawley Headboard should be cleaned using a soft damp cloth and dried
immediately. Do not use a very wet cloth or allow any liquid contact for a long
period of time as this can permanently damage the surface.
Do not use abrasive cleaner or harsh detergent as this can damage the surface.
Do not drag any object across the bed as this can cause permanent damage.
Please retain this information leaflet for future reference.
This product complies with BS 4875-7 2006 part 6.6 of BS EN 14749:2005
John Lewis Partnership 171 Victoria Street, London, SW1E 5NN.
www.johnlewis.com
If you require any additional information or have any issues with this product
please call the John Lewis Helpline on 01244 689949 or email
[email protected]