John Lewis JL Almera User manual

1
John Lewis
JL Almera Dining Table
Stock number: 820/31801
Thank you for purchasing this JL Almera Dining Table. Please read the instructions carefully before use
to ensure safe and satisfactory operation of this product.
Pre-Assembly Preparation
Please ensure instructions are read in full before attempting to assemble this product
Necessary Tools
Please check the pack contents before attempting to assemble this product. A full checklist of
components is given in this leaflet. If any components are missing, please contact the retailer from whom
you bought this product.
This product is HEAVY, it should be assembled as near as possible to the point of use. TAKE CARE
WHEN LIFTING to avoid personal injury and (or) damage to the product.
This product takes approximately 15 MINUTES to assemble with 2 PEOPLE.
The fittings pack contains SMALL ITEMS which should be KEPT AWAY FROM YOUNG
CHILDREN.

2
Fittings and Parts Checklist
A
Table top
D
Hex Nut
x8
B
Table leg
x4
E
Parasol
Hole
Plug
C
Flat
Washer
x8
F
Spanner

3
Step by Step Assembly Instructions
Step One
1. Place Table Top (A) up-side-down on a clean, dry & smooth surface that will not scratch the
table top.
2. Attach the Table Legs (B) to the Table Top (A) using Flat Washers (C), and Hex Nut
(D) as shown in diagram below.
3. Fully tighten the nuts with the Spanner (F).
______________________________________________________________
Step Two
1. with the help of another person, carefully turn
the table the right way up, taking care not to
pivot on legs.
2. Place Parasol Hole Plug (E) in central hole
and remove as required to insert parasol.
____________________________________________________________________________
Step Three
1. Ensuring that the table is on a flat even surface
with all 4 legs in contact with the ground, the
table is now ready to use.

4
Care and Maintenance
How to Care for your Wooden Garden Furniture
This product is made from FSC TEAK a resinous hardwood. Wood is a natural material and its colour
can vary. Wood absorbs and releases moisture so different types of weather will greatly influence the
long term look of the product. It is highly recommended that you treat the furniture in order
to maintain the original appearance for longer. This should be done before the furniture is
placed outside for the first time.
There is a choice of how to treat the furniture. Proprietary finishes such as good quality oils or wood
stains will help to protect the surface and maintain the original appearance.
Wood Oil
Good quality hardwood furniture oil/teak oil can help to maintain and protect the surface of the wood.
The frequency of application depends on the weather conditions. As a guide we recommend repeating
the process at the beginning and end of every season. Wood oils are a more natural finish but do not
provide the same level of protection as wood stains.
Wood Stain
Wood stains are surface coatings that reduce fading caused by sunlight and protect the timber against
wetting and drying which leads to shrinkage and swelling. Wood stains generally last for 2 or 3 years if
manufacturers instructions are followed correctly.
To extend the product life and appearance it is advisable to store the furniture in a cool dry place
over winter. Ensure that the furniture is clean and completely dry before putting in to storage. Do NOT
enclose the product in a plastic or other non-permeable material as this promotes the growth of mildew
and mould.
Safety Instructions
Never drag furniture when moving it, always lift it.
Periodically check all fixings to ensure none have come loose and re-tighten where necessary.
Please take care when handling or moving the furniture as careless handling may cause damage or injury.
This furniture has been designed for domestic use only.
Ensure that the furniture is always on a solid and level surface and the legs are in contact with the
ground at all times.
Parasols should be used with a separate weighted base to ensure stability. Never leave parasol open and
unattended when not in use.
Do not place very hot or very cold items on the table surface(s) unless adequately thick table mats are
used to prevent such items from coming into contact with the table.
Do not sit or stand upon the table surface(s)
Do not use the table as a chopping surface. Do not strike the table with hard or pointed items.
Protect furniture from severe weather conditions (e.g. high winds, torrential rain).

5
This product complies with:
BS EN581-1:2006
BS EN581-3:2007
PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
John Lewis Partnership 171 Victoria Street London SW1E 5NN
www.johnlewis.com