John Thomas TT30 User manual

ITEM NO.: TT30
REVISED JUN 15, 2015
Printed in Vietnam
- 1 -
ASSEMBLY INSTRUCTIONS
Description
Item No.
: 30H TEA TABLE
: TT30

ITEM NO.: TT30
REVISED JUN 15, 2015
Printed in Vietnam
- 2 -
BEFORE ASSEMBLY
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning
assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is
missing or defective, please contact the store where purchased. If hardware is missing, or you need help with
assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
-Remove all wrapping material, including staples & packing straps before you start to assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
WARNING:
Long exposure to rubber or soft plastic may cause a chemical reaction and damage the finish of your
table. Protect the surface of the table with cloth if you are using any product with rubber feet or base.
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO Description Qty Sketch NO Description Qty Sketch
A LEG
FRAME 2
B APRON 2
C TOP 1
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

ITEM NO.: TT30
REVISED JUN 15, 2015
Printed in Vietnam
- 3 -
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO Description Qty Sketch NO Description Qty Sketch
1 BOLT
(M6x60mm) 4 2
BARREL
NUT
(M6x13mm)
4
3 SCREW
(M4x35mm) 4
4
WOOD
PLUG
(14.5mm)
4
5 ALLEN KEY
(M4x80mm)
1
Attach the Aprons (B) to leg frames (A) with bolts (1) and barrel nuts (2), as shown below. Tighten with
Allen key (5).
STEP 1

ITEM NO.: TT30
REVISED JUN 15, 2015
Printed in Vietnam
- 4 -
STEP 2
Attach top (C) to the aprons and leg frames (from step 1) with screws (3). Tighten with a screwdriver.
Then insert wood plugs (4) over bolts to cover them.