John Thomas OT-47ER User manual

ITEM NO.: OT-47ER
ISSUED MAR 09, 2021
Printed in Vietnam
- 1 -
ASSEMBLY INSTRUCTIONS
Description
Item No.
: LIBRARY END TABLE ROUND
: OT-47ER

ITEM NO.: OT-47ER
ISSUED MAR 09, 2021
Printed in Vietnam
- 2 -
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to
beginning assembly, however, make sure all parts and hardware are included and free of obvious
defect. If a part is missing or defective, please contact the store where purchased. If hardware is
missing, or you need help with assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the
parts from being scratched.
-Remove all wrapping material, including staples & packing straps before you start to assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
WARNING:
Long exposure to rubber or soft plastic may cause a chemical reaction and damage the finish
of your product. Protect the surface of the product with cloth if you are using any product
with rubber feet or base.
BEFORE ASSEMBLY
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

ITEM NO.: OT-47ER
ISSUED MAR 09, 2021
Printed in Vietnam
- 3 -
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
A
Top
1
B
Shelf
4
C
Vertical panel
2
D
Vertical panel
1
E
Bottom shelf
1
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
1
Short Bolt
(M6 x 30mm)
4
2
Long Bolt
(M6 x 40mm)
5
3
Lock Washer
(6.5 x11mm)
9
4
Flat Washer
(6.5 x13mm)
4
5
Flat Washer
(6.5 x19mm)
5
6
Long Screw
(M4 x 35mm)
12
7
Allen Key
(M4 x 30mm x 110mm)
1

ITEM NO.: OT-47ER
ISSUED MAR 09, 2021
Printed in Vietnam
- 4 -
Insert shelves (B) into vertical panels (C) and attach with screws (6) as shown below. Tighten with a
screwdriver.
STEP 2
Attach vertical panels (C) and shelves (B) to vertical panel (D) with screws (6) as shown below. Tighten
with a screwdriver.
STEP 1

ITEM NO.: OT-47ER
ISSUED MAR 09, 2021
Printed in Vietnam
- 5 -
STEP 3
Attach vertical panels (C) and (D) to top (A) with bolts (1), and washers (3) and (4) as shown below.
Tighten with Allen key (7).
STEP 3
STEP 4
Attach bottom shelf (E) to vertical panels (C) and (D) with bolts (2), and washers (3) and (5) as shown
below. Tighten with Allen key (7).
Adjust the levelers to the appropriate height to level the unit.
STEP 3