Jorvet Vet Pro Pump Operating instructions

1. Turn pump ON
2. Press INFO key twice
3. Scroll down with the down- arrow key (0)
to ADJUST SETTINGS.
4. Press START/OK key.
5. Scroll down with the down- arrow key (0)
to MORE.
6. Press START/OK.
7. Using the numeric key pad, input Technician
Code 901
8. Press START/OK key.
9. Scroll down with the down- arrow key (0)
to MAXIMAL RATE.
10. Press START/OK.
11. Input 1200 ml.
12. Press START/OK key.
13. Scroll down with arrow
keys (2, 0) to
RESTART PUMP. Confirm by
pressing START /OK.
Issue: Pump will not rate entry above 500 ml/ hr
A small numeral 3 will be displayed on the upper
right-hand corner of the LCD Display when the Factory
Defaults have been changed.
Solution: Reset factory default Maximal Rate. The Vet
Pro Pump comes with a factory default Maximal Rate of
500ml.
Maintenance & Troubleshooting

A/C icon
Battery Icon
Pump will not charge or hold a charge:
Check to ensure A/C Icon is illuminated- if not try another
cord.
If the AC indicator is illuminated, but not the battery
indicator, check the age of the battery. If available,
temporarily try a battery from another pump. If the pump
then functions, replace the battery (J1097d1).
If still not working call Technical Support .
Maintenance & Troubleshooting
AIR sensors
“AIR” Error - Clean air sensors
with cotton-tipped applicator
and alcohol. Try a new IV set. If
not resolved call Jorgensen
Technical Support.
Jorgensen Technical Support
800-525-5614
Inf[email protected]om