100% Silicone Sealant
IMPORTANT! Risk of product
damage. Overtightening the nuts
may cause irreparable damage to
the lavatory.
IMPORTANT! Provide your
countertop manufacturer with your
lavatory model number. Countertop
manufacturer should preinstall the
anchors into the underside of the
countertop.
CAUTION: Risk of personal
injury.
Product can break, chip, and cause
injury if handled carelessly. Get help
lifting the lavatory.
Observe all local plumbing and
building codes.
Record your model number below
for future reference:
4Generously apply 100% silicone
sealant around the rim.
3Loosely install the clips.
2Clean the underside of the
countertop and the rim of the sink.
1Verify cabinet clearance.Use the anchors and fasteners
provided by the countertop
manufacturer and the clamps
provided with your sink.
DO NOT use adhesives or adhesive
sealants to install this sink.
8Run water into the sink and check
all connections for leaks.
7Complete the faucet and drain
installations.
6Immediately wipe away any
excess sealant. Allow the sealant
to set for 30 minutes before
proceeding.
5Position the lavatory squarely
under the cutout. Draw the
lavatory rim up against the
countertop until it is snug. Hold the
sink in place and rotate each clip
over the rim. Evenly tighten the
clips to secure.
1300842-2-B
