Kallista ONE P24476 User manual

Questions? Problems? For additional assistance, please contact Kallista's Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX [phone].
INSTALLATION INSTRUCTIONS
1080632-2-A
Page 1 of 2
P24476
ONE™ Ceiling Mount Shower Arm
(For 11.8” Rain Showerhead)
THANK YOU FOR CHOOSING KALLISTA
BEFORE YOU BEGIN
TOOLS AND MATERIALS
1. INSTALL THE SHOWER ARM
We appreciate your commitment to Kallista quality products. Please take a moment to review this manual before
you install your Kallista product. If you encounter any installation or performance problems, please do not
hesitate to contact us at the phone number listed at the bottom of the page.
Observe all local plumbing and building codes.
Kallista reserves the right to make revisions in the design of plumbing products without notice, as specified in
the Price Book.
Shut off the main watersupply.
For roughing-in specifications, please refer to the faucet manufacturer’s installation instructions.
Adjustable
Wrench
Hex
Wrench
Thread
Sealant
Plumbers
Putty
Strap
Wrench
Escutcheon
Shower Arm
Apply
clear silicone
sealant.
Showerhead
(Not Provided)
Set Screw

Questions? Problems? For additional assistance, please contact Kallista's Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX [phone].
INSTALLATION INSTRUCTIONS
1080632-2-A
Page 2 of 2
ONE™ Ceiling Mount Shower Arm
(For 11.8” Rain Showerhead)
P24476
1. INSTALL THE SHOWER ARM (cont.)
NOTE: The shower head is not provided.
Remove temporary nipple from the shower ell.
Apply thread sealant tape to the threads of each end of the shower arm.
Place the shower arm in the shower ell.
Carefully tighten the shower arm into the shower ell with a clean strap wrench.
If desired, apply a bead of clear silicone sealant to the back outer edge of the escutcheon.
Being careful not to scratch the shower arm, slide the escutcheon to the ceiling and secure the
escutcheon to the shower arm by tightening the set screw with a hex wrench.
Remove any excess clear silicone sealant.
Turn on the water and allow water to flow through the shower arm to flush the system of any debris.
Turn off the water.
Hand tighten the shower head (not provided) to the shower arm.
Use a clean strap wrench to completely tighten the shower head to the shower arm.
Check for proper operation.
CAUTION: Risk of product damage. To avoid clogging the showerhead spray outlets, use thread
sealant tape on the shower arm threads. Do not use thread sealant compound (pipe dope).