Kallista P21688-00-CP User manual

Installation Guide
Contemporary Bottle Trap Drain
1348276-2-A

Thank You For Choosing Kallista
We appreciate your commitment to KALLISTA quality products. Please
take a moment to review this manual before you install your
KALLISTA product. If you encounter any installation or performance
problems, please do not hesitate to contact us at the phone number
listed on the back cover.
Tools and Materials
Before You Begin
Observe all local plumbing and building codes.
Turn off the water supplies.
Kallista reserves the right to make revisions in the design of basin
drains without notice, as specified in the Price Book.
Strap Wrench Hacksaw Cloth
Blade Screwdriver Tape Measure
1348276-2-A 2 Kallista

1. Assemble the Drain
Install the pop-up drain to the lavatory according to the
manufacturer’s instructions.
Remove the inlet and outlet nuts from the bottle trap body.
Ensure that the O-ring is inside each nut.
NOTICE: To ensure a proper compression fit, the tailpiece must be
inserted at least 1” (25 mm) inside the inlet nut.
With the threads facing down, slide the inlet nut with O-ring onto
the tailpiece.
Place the bottle trap body around the tailpiece at least 1” (25
mm), then handtighten the inlet nut until the nut is flush against
the bottle trap body. If necessary, use a clean strap wrench to
assist you.
To Lavatory
Inlet Nut
O-Ring
Bottle Trap Body
O-Ring
Outlet Nut
Tailpiece
Kallista 3 1348276-2-A

2. Connect the Drain Body
NOTE: The supplied pipe is 14-13/16” (376 mm) in length.
Measure the length from the drain stub-out to the inner-most
edge of the outlet nut. For lengths less than 14-13/16” (376 mm),
cut the length of the pipe using a hacksaw. Be careful not to
damage the finish.
With the threads of the outlet nut facing toward the bottle trap
body, slide the outlet nut with O-ring onto the pipe.
NOTICE: To ensure a proper compression fit, the pipe must be
inserted at least 1” (25 mm) inside the bottle trap body.
Insert the pipe at least 1” (25 mm) inside the bottle trap body.
Handtighten the outlet nut until it is flush against the bottle trap
body. If necessary, use a clean strap wrench to assist you.
Slide the flange onto the free end of the pipe.
Insert the pipe into the drain stub-out with seal (not provided),
then push the flange against the finished wall.
Turn on the water supply, run water through the drain, then
check for leaks.
To Lavatory
Pipe
Flange
Finished
Wall Drain
Stub-Out
Measure.
Outlet
Nut
1348276-2-A 4 Kallista

3. Remove the Debris
Using a flat-blade screwdriver, turn the trap eye counterclockwise
until fully removed from the bottle trap body. Set the trap eye
with O-ring aside.
Clean out any debris that has collected in the bottle trap body.
Reinstall the trap eye with O-ring to the bottle trap body.
O-Ring
Trap Eye
Finished Wall
Kallista 5 1348276-2-A

1348276-2-A

1348276-2-A

USA/Canada: 1-888-4-KALLISTA
Fax: [phone]
kallista.com
©2018 KALLISTA
1348276-2-A