Kallista P21680 User manual

INSTALLATION INSTRUCTIONS
Basin Drain
1207799-2-B
© 2013 KALLISTA
Questions? Problems? For additional assistance, please contact Kallista’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX [phone].
1 of 2
P22050P21680

INSTALLATION INSTRUCTIONS
Basin Drain
1207799-2-B
© 2013 KALLISTA
Questions? Problems? For additional assistance, please contact Kallista’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX [phone].
2 of 2
THANK YOU FOR CHOOSING KALLISTA
We appreciate your commitment to Kallista quality products. Please take a moment to review this manual
before you install your Kallista product. If you encounter any installation or performance problems, please do
not hesitate to contact us at the phone number listed at the bottom of the page.
BEFORE YOU BEGIN
The appearance of your product may differ from the illustrations shown in these instructions, however, the
installation procedure is the same.
Shut off the main water supply.
Observe all local plumbing codes.
Carefully inspect waste and supply tubing for any sign of damage. Replace if necessary.
For new installations, install the faucet before installing the lavatory.
TOOLS AND MATERIALS
1. DRAIN INSTALLATION
Disassemble the stopper (if applicable) and the ange from the drain body.
Apply a small bead of putty or sealant to the bottom of the ange. Insert
the ange into the drain opening. Ensure the gasket is inside the ange.
For grid drains only:
From the underside of the lavatory thread the drain body onto the ange
assembly. Tighten rmly.
For stopper drains only:
From the underside of the lavatory thread the drain body onto the ange
assembly. Tighten rmly.
Install the stopper and tighten rmly.
Turn the drain body so that the word KALLISTA on the stopper is
straight.
For all models:
Tighten the drain body nut rmly while holding the drain body to
maintain the stopper position.
Using a damp cloth, remove any excess putty or sealant.
Ensure that the tailpiece is tightly threaded and connect the trap.
Stopper
Flange
Drain Body
Nut
Tailpiece
Grid
Drain
Flange
Drain Body