Kargo Master 40201 User manual

Kargo Master
Rancho Cordova, CA 95742
800-343-7486
[email protected]
20200414R1 DATE: ________________
Installation Guide
40201

Installation Instructions –40201
For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 1
*PLEASE READ ALL INSTRUCTIONS AND WARNINGS PRIOR TO ASSEMBLING, INSTALLING, AND
USING THIS PRODUCT.*
Warning
Always check for wires, fuel tanks and lines, brake lines and other important vehicle
functionality items prior to drilling and installing all products.
Tools Needed
3/8” Socket and Wrench
7/16” Socket and Wrench
17/64” or H Drill Bit
Drill
Table of Contents
Parts List................................................................................................................................................................... 2
Hardware ................................................................................................................................................................. 2
Step 1 –Assemble Tall Adjustable Tank Strap....................................................................................................... 2
Strap Ajustment....................................................................................................................................................... 3
Before You Begin
Read all instructions prior to assembling or installing any Kargo Master product.
Be sure to put sealant around all threads entering cargo area to prevent water leaking into cargo area.
Verify clearance around installation area for tank before installation.

Installation Instructions –40201
For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 2
Parts List
Hardware
Step 1 –Assemble Tall Adjustable Tank Strap
Determine proper installation location.
Verify clearance around installation area for tank before installation.
Installing the adjustable tank strap requires holes be drilled through installation surface,
so make sure the following clearances and warnings are met.
oBe sure there is proper clearance behind installation surface for bolts and nuts to be installed.
oBe sure there is there is no electrical wiring or fuel lines behind locations marked.

Installation Instructions –40201
For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 3
Remove straps.
Set tank strap bracket in place.
Mark the location of the four slots onto the
installation surface.
Set aside tank strap bracket.
Using a 17/64” (or H) drill bit, drill a hole through
the installation surface at each location marked.
Using four 1/4” x 5/8” flanged hex head screws and four
1/4” flanged lock nuts, install tank strap bracket onto
installation surface.
TIGHTEN all hardware.
Attach straps.
NOTE: Straps may be used in any of the three sets of rings,
depending on tank in use. Taller tanks should use top rings
for stability.
Strap Ajustment
To tighten strap, pull on strap.
To loosen stap, pull outward on strap adjuster flange.
GO BACK AND ENSURE ALL HARDWARE IS
TIGHTENED.
ASSEMBLY IS COMPLETE
MARK &
DRILL
MARK &
DRILL
MARK &
DRILL
MARK &
DRILL
MARK &
DRILL
MARK &
DRILL
MARK &
DRILL
MARK &
DRILL