Kargo Master 4A82T User manual

Installation Guide
4A82T
Kargo Master
Rancho Cordova, CA 95742
800-343-7486
[e-mail]
DATE: ______________

For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 1
Installation Instructions –4A82T
*PLEASE READ ALL INSTRUCTIONS AND WARNINGS PRIOR TO ASSEMBLING,
INSTALLING, AND USING THIS PRODUCT*
Warning
Always check for wires, fuel tanks and lines, brake lines and other important vehicle
functionality items prior to drilling and installing all products.
Tools Needed
13mm Wrench and Socket
Measuring Tape
Table of Contents
Parts List ....................................................................................................................................2
Hardware List ............................................................................................................................2
Ford Transit Installation
Step 1 Rear Foot Mounting .......................................................................................................3
130” Wheelbase
Step 2a 130” WB Front Mount .................................................................................................4
148” Wheelbase
Step 2b Front Mount ................................................................................................................5
Before You Begin
•Read ALL instructions
•Follow the ladder rack instructions to install the ladder rack.
•Be sure to put sealant around exposed threads in roof. Place between the roof and the
rubber pad. Put some on the threads of the bolt going into roof.

For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 2
Installation Instructions –4A82T
Parts
Hardware

For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 3
Installation Instructions –4A82T
Step 1a –130” Wheel base Rear Mount
•Locate the threaded emboss at the rear of the van. Plugs may need to be removed.
•Place the long mount rail on the roof of the van with the
tall flange to the center of the van.
•Bolt through the front most hole in the rail and the
corresponding hole at the rear using M8 x 45mm bolts
with lock washer and flat washers.
•The rail should be offset to the rear of the van as shown.
•Be sure to put the T-249-01 and rubber pad as shown to
comply with the Ford bulletin “Q249”. The rubber pad
goes against the roof.
•Repeat on driver side.
•Snug tighten, allow movement.
Be sure to place sealant in and around threaded emboss in
roof to ensure no water gets into cabin of van.

For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 4
Installation Instructions –4A82T
Step 1b –148”Wheel base Rear Mount
•Locate the threaded emboss at rear of van. Plugs may need to be removed.
•Place the long mount rail on the roof of the van with the
tall flange to the center of the van.
•Bolt through the holes in the rail shown below using M8 x
45mm bolts with lock washer and flat washers.
•The rail should be offset to the rear of the van as shown.
•Be sure to put the T-249-01 and rubber pad as shown to
comply with the Ford bulletin “Q249”. The rubber pad
goes against the roof.
•Repeat on driver side.
•Snug tighten, allow movement.
Be sure to place sealant in and around threaded emboss in
roof to ensure no water gets into cabin of van

For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 5
Installation Instructions –4A82T
130 WB
140 WB
Use instructions included in the ladder rack to complete installation. Once
ladder rack is installed on roof, be sure to TIGHTEN the hardware installed
in these instructions.
**Shown Above, 4A821 installed on 4A82T**