KBL megaSun P9 User manual

01/2022
The rights to technical and design alterations are reserved. KBL GmbH · Ringstraße 24-26 · 56307 Dernbach · Germany
fon +49 (0) 26 89.94 26-0 · fax 94 26-66 · eMail [email protected] · www.kbl.de
Service information: SI00094 1/3
Service information
Topic: Retrot lter capacitors in the canopy
Subject: P9/P9S (5018) devices
This operating manual is intended for use by
• qualied, trained and authorized service technician.
• qualied electrician.
DANGER
Live parts
Risk of death or fatal injury due to electric
shock when touching live parts.
• Switch neutral
• Secure against reconnection
• Check for neutrality
• Ground and short-circuit
• Cover or shield any adjacent live parts or
components
SAFETY ADVICE
Before carrying out any maintenance work, the tanning device must be disconnected from
the mains voltage and secured against being switched on again.
❶
Remove the old lter capacitor.
• Disconnect the old capacitor at the plug
connector (as shown in the image).
• Loosen the cable ties.
• Disconnect ground connection.
Depending on the delivery status, one or
two capacitors are installed.
• Only remove the capacitor at the lower
LED panel.

01/2022
The rights to technical and design alterations are reserved. KBL GmbH · Ringstraße 24-26 · 56307 Dernbach · Germany
fon +49 (0) 26 89.94 26-0 · fax 94 26-66 · eMail [email protected] · www.kbl.de
Service information: SI00094 2/3
❷
Install new lter capacitors.
• Connect new capacitor (as shown in
the image).
• Fixate loose cables with cable ties.
Connect wiring harness
with two capacitors to
the lower LED panel.
If capacitor is missing, connect
wiring harness with one capaci-
tor to the upper LED panel.

01/2022
The rights to technical and design alterations are reserved. KBL GmbH · Ringstraße 24-26 · 56307 Dernbach · Germany
fon +49 (0) 26 89.94 26-0 · fax 94 26-66 · eMail [email protected] · www.kbl.de
Service information: SI00094 3/3
Connect ground wires.
PH2
❸
ATTENTION
In order to ensure the effectiveness, insert
the tooth lock washer between the screw
head and the ring lug contact of the con-
necting cable.