Knight Cubit Ice User manual

Tools Required:
Assembly Instructions
Powered screwdriver
Cubit Ice
Double Sided Desks

Page 1
Assembly Instructions
Cubit Ice Double Sided Desks
WARNING: FAILURE TO COMPLY WITH OR OBSERVE ALL ASSEMBLY,
SAFETY AND OPERATION INSTRUCTIONS AND WARNINGS
REGARDING THE USE OF THIS PRODUCT MAY RESULT IN SERIOUS
BODILY INJURY.
IMPORTANT NOTES!
Prior to installment, use or maintenance of the desk frame, any installer and any
user of the desk must study this assembly and operation manual carefully, so as to
gain a complete understanding of its content.
WARNING
!
knightgroup.co.nz

Page 2
Assembly Instructions
Cubit Ice Double Sided Desk
Step1
Assemble frames & rails together, loosely
( turn from tight).
Step3
Fix desk top with mm overhang over metal
frame. Where desktops butt together, make
sure these are fitted tight together.
Step4
Slide centre screen pole over bracket.
Carefully remove end seal on centre screens &
fit screen between end brackets & screw self
tappers to fix screen tightly.
Step2
Assemble screen brackets to frame, loosely
( turn from tight).
knightgroup.co.nz

Page 3
Assembly Instructions
Cubit Ice Double Sided Desks
Step5
Attach centre screen end seal and top cap
with soft non-marking mallet.
Step8
If for whatever reason you have to remove
the top seal, then to refit, slightly arc in the
middle, placing the  ends into location, &
gently tap down.
Step6
Attach screens to centre pole with top slug
connectors.
Step7
Install all top caps simultaneously down
all together gently tapping with a soft non-
marking mallet.
knightgroup.co.nz

Page 4
Assembly Instructions
Cubit Ice Double Sided Desks
Step9
Fully tighten all rail to frame screws, & then
screen bracket screws.
Completed
Step10
Attach cable trays with screws provided.
knightgroup.co.nz