Knight Eko Workstation User manual

knightgroup.co.nz
Tools Required: Powered Screwdriver
Assembly Instructions
Eko Workstation

Page 1
Assembly Instructions
knightgroup.co.nz
Eko Workstation
• To prevent possible scratches or damage, assemble
the desk upside down on a soft surface such as a
blanket, carpet or packaging.
• Attach leg to the top assembly by using bolts, spring
washer, flat washer. Tighten using the allen wrench.
Recommended
2-person Step

Page 2
Assembly Instructions
knightgroup.co.nz
Step 1
Page 2
Assembly Instructions
Insert dowel pins (d1) into panel D. Insert cam bolts (c1) and dowel pins (d1) into panels X, Z, Y1 & Y2, then turn the
panel Y around 180° and insert cam bolts (c1) into panel Y1.
Eko Workstation

Page 3
Assembly Instructions
knightgroup.co.nz
Page 3
Assembly Instructions
Fix cams on panel Y2 into cam bolts (c1) on panel Y1 and fully tighten.
Step 3
Insert cam bolts (c1) into panel A1 and A2.
Step 2
Eko Workstation

Page 4
Assembly Instructions
knightgroup.co.nz
Page 4
Assembly Instructions
Fix cams on panel D into cam bolts (c1) on panels X and Y1 and fully tighten.
Step 5
Fix cams on panel D into cam bolts (c1) on panels Z and Y2 and fully tighten.
Step 4
Eko Workstation

Page 5
Assembly Instructions
knightgroup.co.nz
Page 5
Assembly Instructions
Complete
Attach connectors (c3) to panels A1 & A2 with screws (s5) and fully tighten. Insert the connector (c4) into panels A1 &
A2 and fully tighten. Cover the cam covers (c2) on the top of the cams. Connect panel D and panel X, Y, Z by using
bracket (b1).
Step 6
Eko Workstation