Knight Ergoplan Boardroom Table User manual

knightgroup.co.nz
Tools Required: Powered Screwdriver
Assembly Instructions
Ergoplan Boardroom Table

Assembly Instructions
knightgroup.co.nz
Ergoplan Boardroom Table
Recommended
2 Person Assembly
Thank you for purchasing Knight product, please carefully read the assembly instructions prior to installment to gain a complete
understanding of the product. It provides you with important information about the safety, use, installation and maintenance.
WARNING: FAILURE TO COMPLY WITH OR OBSERVE ALL ASSEMBLY, SAFETY AND OPERATION INSTRUCTIONS REGARDING
THE USE OF THIS PRODUCT MAY RESULT IN SERIOUS BODILY INJURY.
SAFETY
• The product must be used in a safe manner. Inappropriate use may cause damage to the product and/or cause bodily harm to
the user or persons nearby.
• Don’t locate furniture in direct sunlight or near air-conditioning inlet or heating radiator.
• Don’t put high-temperature or frozen objects on furniture.
• Safely carry product to location of assembly.
• Retain this operation manual and pass it on to any future owner.
SET UP AND INSTALLATION
• Assemble the product according to the assembly instructions.
• To prevent possible scratches or damage, assemble the product on a soft surface such as a blanket, carpet or packaging.
• Place the product a safe distance from window frames, radiators, furniture etc. so that persons cannot become trapped.
It is recommended that this product is assembled by 2 people.
Any questions contact Knight on 0800 143 143
Due to continuous improvement of our products, our assembly instructions may not be in complete accordance with the product
and we apologise in advance.

Assembly Instructions
knightgroup.co.nz
Ergoplan Boardroom Table
Parts
The turning direction
of attaching
Incorrect Correct
A
X
Z
D
Item Description Quantity
ATop Panel 1
XLeft Side Base Panel 1
ZRight Side Base Panel 1
DCentre Base Panel 1

Assembly Instructions
knightgroup.co.nz
Parts
Cam
(pre-installed)
Ergoplan Boardroom Table
c1 6x35 Cam Bolt d1 8x30 Dowel Pin c2 Cam Sticker b1 Bracket s1 3.5x15 Screw
Item Description Quantity
c1 6x35 Cam Bolt 10
d1 8x30 Dowel Pin 10
c2 Cam Sticker 10
b1 Bracket 4
s1 3.5x15 Screw 16

Page 1
Assembly Instructions
knightgroup.co.nz
Step 1
Page 1
Assembly Instructions
Preparation for top panel A, left side panel X and right side panel Z.
lnsert cam bolts (c1) and dowel pins (d1) into the panels Z, X and A.
Ergoplan Boardroom Table
A
Z
X
c1
d1
c1
d1

Page 2
Assembly Instructions
knightgroup.co.nz
Page 2
Assembly Instructions
Ergoplan Boardroom Table
Centre base panel D, left side panel X and right side panel Z assembly.
1. Insert cam bolts (c1) on panel X and Z into panel D and tighten cams in a clockwise direction.
2. Secure panel X & D and panel Z & D with brackets (b1) using screws (s1).
Step 2
D
Z
X
b1
s1

Page 3
Assembly Instructions
knightgroup.co.nz
Page 3
Assembly Instructions
Top panel A assembly.
1. Insert cam bolts (c1) on panel A into cams on panels Z, D and X and tighten in a clockwise direction.
2. Cover top of cams with cam stickers (c2).
3. Turn boardroom table over to upright position.
Step 3
Ergoplan Boardroom Table
D
A
X
Z
c2
c2
c2 c2

Page 4
Assembly Instructions
knightgroup.co.nz
Page 4
Assembly Instructions
Complete
Ergoplan Boardroom Table