Knight Cubit System DSD User manual

knightgroup.co.nz
Tools Required: Powered Screwdriver
Assembly Instructions
Cubit System DSD

Page 1
Assembly Instructions
knightgroup.co.nz
Cubit System DSD
WARNING: FAILURE TO COMPLY WITH OR OBSERVE ALL
ASSEMBLY, SAFETY AND OPERATION INSTRUCTIONS AND
WARNINGS REGARDING THE USE OF THIS PRODUCT MAY
RESULT IN SERIOUS BODILY INJURY.
IMPORTANT NOTES!
Prior to installment, use or maintenance of the desk frame, any installer and any
user of the desk must study this assembly and operation manual carefully, so as
to gain a complete understanding of its content.
WARNING
!

Page 2
Assembly Instructions
knightgroup.co.nz
Step 1
Step 3
Step 2
Step 4
Page 2
Assembly Instructions
Fix desk top with 5mm overhang over metal frame.
Where desktops butt together, make sure these are
fitted tight together.
Slide centre screen pole over bracket. Carefully remove
end seal on centre screens & fit screen between end
brackets & screw self tappers to fix screen tightly.
Assemble frames & rails together, loosely
(1 turn from tight).
Assemble screen brackets to frame, loosely
(1 turn from tight).
Cubit System DSD

Page 3
Assembly Instructions
knightgroup.co.nz
Page 3
Assembly Instructions
Step 5 Step 6
Step 8Step 7
Install all top caps simultaneously down all together
gently tapping with a soft non-marking mallet.
If for whatever reason you have to remove the top
seal, then to refit, slightly arc in the middle, placing
the 2 ends into location, & gently tap down.
Attach centre screen end seal and top cap with soft
non-marking mallet.
Attach screens to centre pole with top slug
connectors.
Cubit System DSD

Page 4
Assembly Instructions
knightgroup.co.nz
Page 4
Assembly Instructions
Step 9 Step 10
Fully tighten all rail to frame screws, & then screen
bracket screws.
Attach cable trays with screws provided.
Complete
Cubit System DSD