Knight Team Meeting Table User manual

knightgroup.co.nz
Assembly Instructions
Tools Required: Powered Screwdriver, 4mm and 6mm Allen Key.
Team Meeting Table

Page 1
Assembly Instructions
knightgroup.co.nz
Team Meeting Table
Recommended
2-person Step
1
2
3
7
6
8
4
9
5
COMPONENTS
1Leg x4
2Adjustable Foot x4
3Leg Cable Cover x4
4Rail x4
52 Way Connector x4
62 Way Connector Cap x4
7Table Top x1
SCREWS
8M8x12mm Dome Head x8
9M8x20mm Cap Head x4
10 10Gx20mm Self Tapping x8
WARNING: FAILURE TO COMPLY WITH
OR OBSERVE ALL ASSEMBLY, SAFETY AND
OPERATION INSTRUCTIONS AND WARNINGS
REGARDING THE USE OF THIS PRODUCT MAY
RESULT IN SERIOUS BODILY INJURY.
IMPORTANT NOTES!
Prior to installment, use or maintenance of the desk
frame, any installer and any user of the desk must study
this assembly and operation manual carefully, so as to
gain a complete understanding of its content.
WARNING
!
To prevent possible scratches or damage,
assemble the table upside down on a
soft surface such as a blanket, carpet or
packaging.
Attach leg to the top assembly by using
bolts, spring washer, flat washer. Tighten
using the allen wrench.

Page 2
Assembly Instructions
knightgroup.co.nz
Page 2
Assembly Instructions
Note:
Step 1 Step 2
Step 3
Securely connect legs to rails lengths using the M8x-
12mm dome head bolts.
*Supplied top may have pre-drilled holes, these
holes are NOT used & new holes need to be drilled
separately for the Team table frame.
Slide the 2 way connectors over each leg, and
securely lock into place using M8x20mm cap head
bolts.
Securely connect legs to rails lengths using the M8x-
12mm dome head bolts.
Team Meeting Table

Page 3
Assembly Instructions
knightgroup.co.nz
Page 3
Assembly Instructions
Team Meeting Table
Step 4 Step 5
Conceal any power box cables using the magnetic
leg cable covers.
Completed
Ensure the worksurface is centered over the frame. Pre-
drill holes in the worksurface. Fully tighten all 10Gx20mm
self tapping screws through each leg and rail spacer
bracket into the worksurface.