Knight Team Meeting Table User manual

knightgroup.co.nz
Assembly Instructions
Tools Required: Powered Screwdriver, Rubber Mallet, 4mm and 6mm Allen Key.
Team Meeting Table

Page 1
Assembly Instructions
knightgroup.co.nz
Team Meeting Table
Recommended
2-person Step
1
2
3
7
6
8
4
9
5
COMPONENTS
1Leg x4
2Adjustable Foot x4
3Leg Cable Cover x4
4Rail x4
52 Way Connector x4
62 Way Connector Cap x4
7Table Top x1
SCREWS
8M8x12mm Dome Head x8
9M8x20mm Cap Head x4
10 10Gx20mm Self Tapping x8
WARNING: FAILURE TO COMPLY WITH
OR OBSERVE ALL ASSEMBLY, SAFETY AND
OPERATION INSTRUCTIONS AND WARNINGS
REGARDING THE USE OF THIS PRODUCT MAY
RESULT IN SERIOUS BODILY INJURY.
IMPORTANT NOTES!
Prior to installment, use or maintenance of the desk
frame, any installer and any user of the desk must study
this assembly and operation manual carefully, so as to
gain a complete understanding of its content.
WARNING
!
To prevent possible scratches or damage,
assemble the table upside down on a
soft surface such as a blanket, carpet or
packaging.

Page 2
Assembly Instructions
knightgroup.co.nz
Page 2
Assembly Instructions
Note:
Step 1 Step 2
Step 3
Securely connect legs to rails using the M8x12mm
dome head bolts. To secure rails to connectors
place the rail onto the connector and firmly tap
the end of the rail with a rubber mallet.
Supplied table top may have pre-drilled holes on the
underside, these holes may not align to your specific
frame. If this is the case, the frame will need to be
aligned to the top and new holes drilled separately
and screws provided used.
Slide the 2 way connectors over each leg, and
securely lock into place using M8x20mm cap
head bolts.
Securely connect legs to rails using the M8x12mm
dome head bolts.
Team Meeting Table

Page 3
Assembly Instructions
knightgroup.co.nz
Page 3
Assembly Instructions
Team Meeting Table
Step 4 Step 5
Conceal any power box cables using the clip leg
cable covers.
Completed
Ensure the worksurface is centered over the frame.
Pre-drill holes in the worksurface. Fully tighten all
10Gx20mm self tapping screws through each leg.