Knight Team Flip Table User manual

Tools Required:
Installation Guide
Powered screwdriver.
Team Flip Table

knightgroup.co.nz
Page 2
Assembly Instructions
Step 1
Fit the pull bar to the top side of the mechanism
according to the number corresponding to your
worksurface depth. This number will locate over
of the raised cylinder
Step 2
Place the pull bar (a) and cross tube (b) in the
correct location pictured below, slide the  end
legs in place, and tighten  small screws into
the cross tube.
Step 4
On all tables with width larger than mm,
secure the pull bar with the supplied washer and
screw in the location pictured below (slot end
closest to the pull-bar). Leave screw  turn from
tight so the pull-bar can be operated smoothly.
Step 3
Ensure the frame is located in the centre of
the worksurface. Fully tighten all  screws on
each mechanism.
(b)
(a)
Team Flip Table

knightgroup.co.nz
Page 3
Assembly Instructions
Hole position for optional connector
Drilling patterns for Team Flip Tables
170mm
C
114mm
B B
138mm 138mm64 64
A
2x 2mmØx12mm h
12x 2.5mmØx15mm h
25mm
Table Length
Table Width
294mm
Width-700mm A B C
mm   NA
mm   NA
mm   NA
Width-900mm A B C
mm   
mm   
mm   
Width-800mm A B C
mm   
mm   
mm   
Team Flip Table
Locked
Unlocked
1.5mm pilot hole
70 70 181181
19 19
19
35 35
19