Knight Ergoplan User manual

knightgroup.co.nz
Tools Required: Powered Screwdriver
Assembly Instructions
Ergoplan Meeting Table

Assembly Instructions
knightgroup.co.nz
Recommended
2 Person Assembly
Thank you for purchasing Knight product, please carefully read the assembly instructions prior to installment to gain a complete
understanding of the product. It provides you with important information about the safety, use, installation and maintenance.
WARNING: FAILURE TO COMPLY WITH OR OBSERVE ALL ASSEMBLY, SAFETY AND OPERATION INSTRUCTIONS REGARDING
THE USE OF THIS PRODUCT MAY RESULT IN SERIOUS BODILY INJURY.
SAFETY
• The product must be used in a safe manner. Inappropriate use may cause damage to the product and/or cause bodily harm to
the user or persons nearby.
• Don’t locate furniture in direct sunlight or near air-conditioning inlet or heating radiator.
• Don’t put high-temperature or frozen objects on furniture.
• Safely carry product to location of assembly.
• Retain this operation manual and pass it on to any future owner.
SET UP AND INSTALLATION
• Assemble the product according to the assembly instructions.
• To prevent possible scratches or damage, assemble the product on a soft surface such as a blanket, carpet or packaging.
• Place the product a safe distance from window frames, radiators, furniture etc. so that persons cannot become trapped.
It is recommended that this product is assembled by 2 people.
Any questions contact Knight on 0800 143 143
Due to continuous improvement of our products, our assembly instructions may not be in complete accordance with the product
and we apologise in advance.
Ergoplan Meeting Table

Assembly Instructions
knightgroup.co.nz
Ergoplan Meeting Table
Parts
Item Description Quantity
ATop Panel 1
ZCentre Panel 1 1
XCentre Panel 2 1
Item Description Quantity
c1 6x35 Cam Bolt 8
d1 8x30 Dowel Pin 8
c2 Cam Sticker 8
The turning direction
of attaching
Incorrect Correct
c1 6x35 Cam Bolt d1 8x30 Dowel Pin c2 Cam Sticker Cam
(pre-installed)
A
XZ

Page 1
Assembly Instructions
knightgroup.co.nz
Step 1
Page 1
Assembly Instructions
Preparation for top panel A.
1. Place top panel on level suface with underneath of top facing upwards.
2. Insert cam bolts (c1) and dowel pins (d1) into panel A.
Ergoplan Meeting Table
A
c1
d1

Page 2
Assembly Instructions
knightgroup.co.nz
Page 2
Assembly Instructions
Centre panel Z and top panel A assembly.
Insert cam bolts (c1) on panel A into cams on panel Z and tighten in a clockwise direction.
Step 2
Ergoplan Meeting Table
A
Z
c1
d1

Page 3
Assembly Instructions
knightgroup.co.nz
Page 3
Assembly Instructions
Step 3
Ergoplan Meeting Table
Centre panel X and top panel A assembly.
1. Slide gap in panel X over gap in panel Z.
2. Insert cam bolts (c1) on panel A into cams on panel X and tighten in a clockwise direction.
3. Cover top of cams with cam stickers (c2).
4. Turn table over to upright position.
A
Z
X
c2
c2

Page 4
Assembly Instructions
knightgroup.co.nz
Page 4
Assembly Instructions
Ergoplan Meeting Table
Complete