
height “bot”, release “ ” down keys, the reset is over and the table can be used normally.
b.when the table doesn’t work and LED shows” E01” or “E02”, pls retry 18mins later.
Reconnect the power and press “ ” keys to start and reset process when it shows the “RST”
Troubleshooting
below.
8
Wireless Charging logo
Wireless Charging Function
Fault phenomenon Method Fault phenomenon Method
No response while long pressing
a power supply
1.Check if all the cables be connected well
2.Contact your supplier or dealer
No response while pressing up
connected with a power supply
1.Check if all the cables be connected well
2.Contact your supplier or dealer
Rising in a low speed
2.Contact your supplier or dealer
The motor not move as instructed 1. Contact your supplier or dealer
2.Contact your supplier or dealer
Go down but not go up
Downward sliding
2.Contact your supplier or dealer
Overwork
()
2.Contact your supplier or dealer
with power;
2.Contact your supplier or dealer;
Not enough up&down height
2.Contact your supplier or dealer