KOBLE Naples GFNAPC Manual

Care & Instruction Manual
Please read and retain these instructions for future
reference
STOCK CODES : GFNAPC
Imported By: Koble Designs (Justwise Group Ltd). CB11 3AP.
Issue 1 - 03/02/22
Naples Furniture Set - Armchair

2
Safety and Care Advice
Check you have all the
components and tools listed on
pages 3 and 4.
Remove all fittings from the
plastic bags and separate them
into their groups.
Small parts could choke if
swallowed, keep children and
animals away from work area.
Make sure you have enough space
to layout the parts before starting.
Assemble the item as close
to its final position (in the same
room) as possible.
Assemble on a soft level
surface to avoid damaging the
unit or your floor.
Assembly requires 2 people.
Do not fully tighten bolts until the
whole bed is assembled. Do not
overtighten the nuts to avoid
causing damage to the threads.
We do not
recommend the
use of power
drill/drivers for
inserting screws,
as this could damage the unit.
Only use hand screwdrivers and
Allen keys.
Dispose of all packaging carefully
and responsibly.
Place product on an even surface
perior to using.
Suitable for Domestic Garden use
only.
Children should not be left alone
in situ with product, please refrain
climbing onto the product.
Frequently check any damage to
the product including the
underside and tighten fixings
where is required.
From time to time check that
there are no loose screws on
this unit.
This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Daily cleaning:
Wipe clean with a damp cloth.
Use only clean water.
Wipe dry with a clean soft
cloth.
Do not use detergents,
solvents or other chemicals on
oiled surfaces, as this may
cause discoloration.
Color stains from eg. red wine
or the like must be wiped o ff
immediately.
For cushion covers, use
sponge clean only.
We recommend the use of
furniture corvers when not
in use.
In order to prolong the life of
your product, we recommned it
be stored in a dry and protected
area during of season periods.
Do not use any abrasive
substance which may scatch
the surface.
Do not stand on seating. Do not sit
on arm or backrest ledges. Give
your hardwood furniture a yearly
scrub with soapy water, followed by
a thorough rinse. This removes
algae and pollution to restore the
timber's surface, keeping it in good
condition.

Seat frame Qty 1 (39x77x41) 2
1
3
Leg frame ( front) Qty 1 (78x77x36cm)
4Back Cushion Qty 1 (66x41x10cm)
5Seat Cushion Qty 1 (66x68x10cm)
3Leg frame (back) Qty1 (78x77x36cm)
For missing or damaged parts, call our Customer Helpline: 01799 513466 or email
[email protected]

BA
M6 Washer Qty 6
allen Key Qty 1
Fixings, Fittings And Tools
4
For missing or damaged parts, call our Customer Helpline: 01799 513466 or email
[email protected]
35mm M6 Bolt Qty 4 20mm M6 Bolt Qty 2
C
D

Twopeoplerequired
7
Step1
Connect leg framesand
togetherasshown.
Note: No screwsare
required.
Step2
2
AssemblySteps
3
Assemble the legsand
to the underside of seat
frame , using fixings,
, and asshown.
Note: Screwsare located
at each side. Screwsin
the centre.
2
1A
BC
3
Ax4 Cx2 Dx1
Bx6
FRONT
BACK
3
2
FRONT
BACK
B
A
3
1
2
Twopeoplerequired
B
A
B
A
B
A
B
C
B
C
C
A