Kohler FAMILY CARE K-706264T-FM-SHP User manual

-1-
BEFORE YOU BEGIN 安装之前
ZHONGSHAN KOHLER SHOWER CO., LTD. NO13-1, XINGYE ROAD, ZHONGSHAN TORCH
DEVELOPMENT ZONE, ZHONGSHAN, GUANGDONG, CHINA POST CODE: 528437
中山科勒卫浴有限公司 广东省中山市中山火炬开发区兴业路 13-1 号邮编：528437
• 说明书中所有的资料是按最新出版的产品资料编写而成。科
勒中国有限公司保留任何时候无须通知即可改变产品特性、
包装或产品可供类型的权利。
• 说明书包括重要的安装、清洁及保养方面的内容，请把这些
资料交给用户阅读，保管。
• 确保在安装淋浴房之前已经完整正确地安装了浴室和完工
墙面材料。淋浴区墙地面应做防水处理，并不得布置有电器
开关、插座。确保地面排水通畅。
• 在进行淋浴房安装之前，请拿出、排列并确认所有的零部件。
请参考第 2 页上所示的分解图。
• 对尺寸与本标准产品不同的定制淋浴房，参照本说明书进行
安装。
• 本产品符合 QB 2584-2007。
• All information is based on the latest product information
available at the time of publication. Kohler China Ltd.
reserves the right to make changes in product
characteristics, packaging, or availability at any time
without notice.
• These instructions contain important care, cleaning, and
warranty information-please leave these instructions for
the consumer.
• Make sure that the bath and the finished wall material are
completely and correctly installed prior to installing your
shower door. Prepare waterproof layer to wall and floor of
the showering area. It is not allowed for any presence of
electric switches and sockets. Make sure the floor drain
runs smoothly.
• Before starting the door installation, lay out and identify all
the parts. Use the exploded view illustrated on page 2 for
reference.
• For the installation method of customized shower with
different dimensions, please refer to this instructions.
• The product complies with QB 2584-2007.
警告：可能有人员伤害或者产品损坏的危险。
钢化玻璃不能进行切割，钻孔或硬物敲击。搬移或安装过
程中，小心确保玻璃边、角部位不受撞击，以防爆裂伤人。
建议：将本产品安装在科勒淋浴盆或挡水条上（需另行购买）。
如自备挡水条，建议顶面宽度尺寸大于 80mm。
重要事项：淋浴房需要安装在平坦垂直的墙面上。墙面的垂直度推
荐在正负 3mm/m 以内。如果超出此范围，科勒公司将不保证淋浴
房的完美使用。
CAUTION: Risk of injury or product damage.
Tempered glass cannot be cut, drilled or knocked by
hard object. Make sure corner area of the glass
refraining from knocking so as to cause personal injury
due to broken glass.
ATTENTION: Please install this door on Kohler receptors or
curbs(Not included). If the curb is not Kohler-branded, please
note its top width should be more than 80mm.
IMPORTANT: The shower door requires a flat vertical
finished wall. The squareness of the wall is recommended no
more than 3 mm/m. KOHLER Company won't take
responsibility of the installation quality.
24hrs
ROUGHING-IN 尺寸图
Unit: mm
单位：毫米
Do not use the enclosure for at least 24 hours.
安装后 24 小时内请勿使用淋浴房。
FAMILY CARE
亲悦
INSTALLATION INSTRUCTIONS
安装说明书
HALF DOOR, 10mm
半扇门， 10mm防爆贴膜玻璃
K-706264T-FM-SHP
SKU B H
706264T-FM-SHP 550-900(mm) 612(mm)
© Copyright Kohler China Investment Co., Ltd. 2019
© 版权为科勒（中国）投资有限公司所有 2019
1386867-T01-A
H
B

Tools Required/所需工具
5mm Allen Key
5mm 六角扳手
2.5mm Allen Key
2.5mm 六角扳手
Masonry Drill &
6mm Drill Bit
冲击钻以及
6mm 冲击钻头
Pencil
铅笔
Level
水平仪
Measuring Tape
卷尺
Phillips Screwdriver
十字螺丝刀
Hammer
锤子
Knife
刀片
Caulk Gun
硅胶枪
Safety Goggles
护目镜
-2-
X2
X2
X4
X1
X1
X6
1386867-T01-A
1313024
Lock Seat With Water Diveter
靠墙门栓座
1313012
Lock Seat With Water Diveter
靠挡水条固定座
1102106
Fixed Screw
十字不锈钢平头自攻丝
螺钉 ST3.7×40
Half Door Components
门玻组件
Protected Strip 保护胶条
Lock Seat With Water Diveter 靠墙门栓座
Lock Seat With Water Diveter 靠挡水条固定座
Fixed Screw 十字平头自攻丝螺钉 ST3.7×40
Hollow Wall Anchor, Nylon 膨胀套
Pan Screw ST3.5×40 圆头螺丝 ST3.5×40

-3-
1386867-T01-A
STEP
3
STEP
4
STEP
1
STEP
2
INSTALLATION 安装
IMPORTANT:
Tray MUST be level
along front edge.
重要：
底盘必须水平。
0mm
20
20
6mm
0mm
The wall jamb
must be kept
vertical.
上墙材必须垂直。
1. As shown in the figure below, install the door glass 20 mm above the ground and make
sure the end surface of the hinge, after being opened, presses tightly against the weather
bar (or the wall jamb if no weather bar is present) and its rear presses against the wall.
2. Use a level to make sure that the end surface of the half door hinge is perpendicular to the
ground.
3. Mark the screw holes with a pencil as shown in the figure below. Then drill holes and
install the hollow wall anchor into the wall.
4. Fix the half door onto the wall.
1. 参考下图，门玻底部距离地面20mm，铰链打开端面紧靠挡水条（没有挡水条的紧靠墙材）背面
靠墙壁。
2. 用水平仪测量，使半门铰链端面与地面垂直。
3. 参考下面方式，用铅笔标记螺钉孔位置，然后钻孔将膨胀套装入墙壁。
4. 将半门与墙壁固定。 The surface indicated by the arrow
presses tightly against the curb
箭头所指平面紧靠挡水条
1. Cover the lock seat with water diveter on the bolt and press it tightly against the wall.
Mark the position with a pencil.
2. Drill a hole and install the hollow wall anchor by reference to step 1.
3. Install the lock seat with water diveter.
4. Cover the lock seat with water diveter on the bolt and press it tightly against the weather
bar. Mark the position with a pencil. Drill a hole and install the hollow wall anchor. Then
install the lock seat.
1. 将靠墙门栓座套入插销，紧靠墙壁，用笔标记好位置。
2. 参考第一步方法钻孔，装膨胀套。
3. 安装靠墙门栓座。
4. 将靠挡水条固定座，套入插销，紧靠挡水条，用笔标记好位置，然后钻孔，装膨胀套，再安装好
固定座。
1. Apply sealant around the lock seat of the bolt.
1. 插销固定座周围打胶。
1. Install the half door inside the enclosure.
2. Refer to the shower instructions for how to install the weather bar and the shower.
1. 半门安装在淋浴房内部。
2. 挡水条和淋浴房安装，参考对应淋浴房说明书。