Koolatron LENTEK Bug Vacuum BV01-K User manual

HAND-HELD ELECTRONIC SPIDER & INSECT TRAP
H1S109 Please Read These Instructions Carefully Before Use!
12/2020 - v4
Warranty
This product is warranted to the retail customer for 90 days from date of retail purchase, against
defects in material and workmanship.
WHAT IS COVERED
• Replacement parts and labour.
• Transportation charges to customer for the repaired product.
WHAT IS NOT COVERED
• Damage caused by abuse, accident, misuse, or neglect.
• Transportation of the unit or component from the customer to Koolatron.
IMPLIED WARRANTIES
Any implied warranties, including the implied warranty of merchantability are also limited
to the duration of 90 days from the date of retail purchase.
WARRANTY AND SERVICE PROCEDURE
Keep the original, dated, sales receipt with this manual. If you have a problem with your unit, or
require replacement parts, please telephone the following number for assistance:
North America 1-800-265-8456
Koolatron has Master Service Centres at these locations:
U.S.A. - 4330 Commerce Dr., Batavia, NY 14020-4102
Canada - 139 Copernicus Blvd., Brantford, ON N3P1N4
A Koolatron Master Service Centre must perform all warranty work.
www.koolatron.com
©2021 Koolatron, Inc. All rights reserved.
All specification are subject to change without notice.
Made in China
BV01-K
Adapter Included!
capture tip
trap door
telescopic tube
detachable tube
high voltage grid
safety interlocks
hand-held unit
power ON light
ON/OFF switch
charging indicator
base stand/charger
User Manual

PRODUCT DESCRIPTION
DISPOSE OF INSECTS AND OTHER PESTS THAT VENTURE INTO YOUR HOME
WITHOUT CONTACT.
No more chasing bugs around your home! Lentek’s Bug Vacuum is a stylish unit
that creates a high-powered suction that captures and kills unwanted pests. It is
an efficient and non-toxic way of getting rid of bugs, insects and other pests that fly
into the house, office or porch. It is easy to operate - attach and detach!
EASY, CONVENIENT OPERATION
The Bug Vacuum is uniquely designed with a trap door near the tip of the vacuum
nozzle. Once the insect has been sucked up through the vacuum, the insect reaches
a high voltage grid at the base. After the insect is trapped, all you have to do is snap
open the vacuum and dump out the contents, and once again you will be bug free!
PRACTICAL FEATURES
A built in safety mechanism in the vacuum instantly deactivates the high voltage grid
when the nozzle is removed for emptying. The convenient and stylish base keeps
your Bug Vacuum fully charged with enough battery power to suck up many bugs,
ready for use in an instant.
• ENDS MESSY SPLATTER ON WALLS AND CEILINGS
• SAFE, CONVENIENT AND SANITARY
• YOU NEVER HAVE TO TOUCH ANOTHER BUG
FEATURES
• Uniquely designed trap door captures pests within vacuum
extension tubes
• Built in high voltage grid safely kills bugs
• Safety interlock disables grid when wand is removed for
insect disposal
• Flexible rubber tip can trap bugs even in corners
• Extendable nozzle to help reach high spots
• Charging stand with LED charge indicators
CAUTION
The Bug Vac is equipped with a safety interlock at the base of the detachable tube
to disable the high voltage grid when the tube is removed. Never jam the interlock
in place. Do Not run the Bug Vac without the tube in place. Never use water or any
cleaner on the high voltage grid. Do Not touch the high voltage grid if and when
pressing the interlock and the ON/OFF switches at the same time.
DIRECTIONS FOR USE
1. For optimum performance, charge the Bug Vac for a full 24 hours before the first
use. Plug the included AC power adapter cord into the base and the adapter into
a standard electrical outlet. Base charge LED light will turn green when Bug Vac is
placed into base unit. Place the hand unit into the base stand with the ON/OFF switch
set to the OFF position. Product performs best during the first minute of use.
Always replace on the charging base after use.
2. The tube assembly length can be adjusted by telescoping the inner tube in or out.
3. The Bug Vacuum activates by sliding the ON/OFF button to the ON position.
When turned on, the red LED light above the switch will illuminate. Suction will be
strongest in the first 5 minutes of use. The red LED will fade and motor sound will
slow as suction power lessens. After disposing of your captured bug, replace hand
unit into the base stand for recharging.
4. Vacuum up the nuisance insect by activating the Bug Vac and placing the capture
tip over the insect. Some insects might require a nudge with the Bug Vac nozzle to
dislodge. All captured bugs may not be killed after being zapped by the high voltage
grid. Bugs should be disposed of safely.
5. Allow the Bug Vac to run for 10 to 15 seconds after the insect has been captured
to assure exposure to the high voltage grid at the base of the hand held unit.
Trap door will shut to keep insect in tube.
6. To empty, turn the Bug Vac to the off position. Remove the detachable tube and
dispose of the insect. The high voltage grid is automatically disabled by removing
the detachable tube.
7. If you prefer to release the captured live insect out of doors, DO NOT push
the detachable tube all the way down on the base. This will leave the safety
interlocks open, disabling the high voltage grid.
REMEMBER
The BV01 Bug Vacuum is designed to capture an insect by vacuuming it up.
The extension wand has a trap door at the inlet to prevent the insect from getting
back out. There is an electrocution grid at the other end of the extension. The insect
is sucked in and killed. The dead insect can then be easily dumped into the trash by
removing the wand from the handle base. If dead insects are left in the unit they may
break apart and pass through the electrocution grid to be blown out with exhaust air.
The electrocution grid has a fine mesh to prevent smaller insects from passing thru
the grid and out of the unit with the exhaust air. The extension wand can be positioned
to deactivate the electrocution grid if a consumer wishes to capture and release
insects outdoors.
* U.S. Patent Number: 6.202.343
SPECIFICATIONS
- Unit Dimensions: 4.63 x 23.5 x 4.63”
- Base Dimensions: 6.35 x 5 x 6.35”
- Safety Standards: ETL approved power supply 5011478
- Adapter Input: 120VAC, 60Hz, 5W
- Adapter Output: 5VDC, 1000mA
- Unit Weight: 26.5 oz.
* Airflow suction is 3500 - 3800 feet per minute (approximately 35.5 MPH) with
a full fresh charge.
* Voltage on the "stunning" grid is 5V when activated.
* For a full recharge between uses, the recharging period should be 24 hrs.
CARE & MAINTENANCE
1. Do not leave this unit outdoors.
2. Do not immerse this unit in water or any other liquid.
3. Unplug before cleaning.
4. Clean with water or a mild detergent on external surface only.
5. Clean detachable tube separately.
6. Do not use harsh solvents on any part of this product.
7. Use the Bug Vacuum only for its intended use.
8. Do not insert objects or fingers into any opening.
9. Keep out of reach of children.