kozy heat TRF-500B User manual

TRF-500B LOG INSTALLATION-R-02
#TRF-500B LOG SET INSTALLATION
For use with #TRF-41-MV and #TRF-41-L
ATTENTION: If installing optional brick refractory please do so now before installing log set. Follow instructions included with kit.
If converting to LP (propane) gas do so now before installing log set. Follow instructions included with kit.
#1 LOG PLACEMENT
NOTE: Log numbers are located on bottom of each log. Refer to following instructions and illustrations for proper placement.
CAUTION: Do not place logs directly over burner port holes. Improper log placement may affect flame appearance and cause excessive
soot to build up on logs and glass.
#2 & #3 LOG PLACEMENT
LP GAS MODELS (only)
Place #1 log onto back log brackets, aligning log bracket pins with alignment holes
in bottom of log while positioning notched out section of log over pilot shield. Set
down onto mounting pins.
LP GAS MODELS: Position back log to create 1/4” (6mm) air space between
back of burner and front of log.
NATURAL GAS MODELS: Position back log so front side of log is resting
against backside of burner tube.
Place left side alignment hole on base log #2, and right side alignment hole on base
log #3 over pins on front log brackets, positioning cut-outs on logs over log grate.
Press logs down onto pins.
BURNER HEAT SHIELD
If installing an optional firebrick refractory set, the break-away tab at front of LP
log plate will need to be removed. Position LP log plate onto back log bracket.
When properly seated, sides of log plate sit between back log brackets and burner
heat shield sides.
BREAK-AWAY TAB
LP LOG PLATE
BACK LOG BRACKET
1
3
2
PAGE 1

LOG SET INSTALLATION cont.
#7, #8 & #9 LOG PLACEMENT
COMPLETE LOG SET INSTALLATION
#11, #12 & #6 LOG PLACEMENT
12
Position #11, #12, and #6 logs onto corresponding cut-outs / notches on base logs.
The #6 log must not extend over front of #2 log.
Position #7, #8 and #9 logs onto corresponding cut-outs / notches on base, center
logs and log grate.
Use a steel or stiff bristle nylon brush to distribute Rock Wool Embers onto logs and
burner.
11
6
9
8
7