Kraus Millennium Series User manual

Product Description and Measurements
Installation Instruction
Contact us toll-free at kraususa.com. 1-800-775-0703; or visit our website at www.
Prior To Installation Steps
1. Unpack your new product and ensure that all the parts are contained in the packaging.
Keep the product in its original box until you ready to install it.
2. Shut off the water supply if replacing a previously-installed faucet.
3. Observe all plumbing and building codes in your area.
4. It is recommended that installation of the product be done by a professional plumber.
Thank You
Single Lever Washbasin Mixer
Dear Valued Customer,
Kraus would like to take this opportunity to thank you for purchasing Kraus products. It is our sincere
hope that you are completely satisfied with your new purchase. We welcome any questions or comments
you may have and look forward to assisting you in the future.
Sincerely,
Kraus customer service department.
MODEL-MIL-1200 (15)
Millennium Series

Contact us toll-free at kraususa.com. 1-800-775-0703; or visit our website at www.
Installation
Do not disassemble the main body, as it has been installed & commissioned
correctly & precisely before leaving the factory.
To avoid the faucet from jamming, DO flush the water pipe before installation.
After installation make sure every joint is safely sealed (NO LEAKAGE).
Make sure to connect the hot/cold inlet pipe correctly form front view hot water
pipe connecting to the left and cold water pipe connecting to the right .
Code Parts List Quantity
1
2
3
4
5
6
7
8
9
10
1
1
1
1
1
1
2
1
1
1
Spout
Handle
Main mixer
Hose
O-ring
Lock washer (rubber)
Lock washer (brass)
Screw pole
Nut
5
6
8
9
10
MODEL-MIL-1200 (15)
4
3
1
2
Joystick
7

Installation
Contact us toll-free at kraususa.com. 1-800-775-0703; or visit our website at www.
1. Grab the handle and pull outward and to the right to open
the faucet.
2. Push the handle back or away from you to increase cold
Usage, Cleaning & Maintenance
Usage
Cleaning & Maintenance
Make sure the installation holes are in the correct size.
Install the lavatory and pop-up waste as shown in the drawing.
Connect the main body and water supply pipe with water inlet pipe
1. Rinse with warm clean water and blot dry with a clean soft
cloth only.
2. Never use any detergent, polisher, scraper or an abrasive
cloth.
3. Do not use acid detergent.
MODEL-MIL-1200 (15)
10’’
9’’
9 3/4’’
19’’
3’’
2’’
3 3/4’’
1 3/4’’
Spout
Lower Body
7’’