Kraus Urbix KPF-3127 User manual

www.kraususa.com I Toll Free: 1.800.775.0703 I © 2018 Kraus USA Inc. I REV. June 16, 2021
Industrial Bar Faucet
KPF-3127
R
INSTALLATION MANUAL

2
Congratulations on the purchase of your new
Kraus plumbing fixture!
Please keep the box and packaging materials until your product is
completely installed. If you have any questions, require technical
assistance or have any problems with your product:
Please contact our Customer Service Team
1-800-775-0703 / [email protected]
Have the model number available and retain a copy of your
receipt with purchase date for reference.
If for any reason this product does not meet your expectations,
please be sure to repack this product in the original box and
packaging material to avoid damage during transit.
DO NOT RETURN TO STORE
STOP

Prior to Installation:
·Make sure you have all necessary parts by checking the diagram and
parts list. If any part is missing or damaged, please contact Kraus
Customer Service at 800-775-0703 for a replacement.
·Turn off the hot and cold water supply at the angle stops and turn on
the old faucet to release any built up pressure. Remove existing faucet.
Clean sink or countertop to remove any debris, plumber’s putty, or
silicone.
·Flush angle stops to release any debris prior to installation.
·Pre-drilled hole size requirement: 1 3/8" (min)
·Max countertop thickness: 2 1/8”
3
Tools Required
For technical assistance or replacement parts, please contact Kraus
Customer Service and one of our representatives will be happy to help:
Toll-Free: 800-775-0703 or [email protected]
Adjustable Wrench Phillips Screwdriver Silicone Sealant
Safety Goggles Pipe Tape

44
Diagram and Parts List
1. Aerator Assembly
2. Faucet Body
3A. Rubber Washer
3B. Metal Washer
3C. Mounting Nut
3D. Mounting Screws
4. Waterlines
1
2
3B
3C
3D
4
3A

55
Faucet Dimensions
Installer Tip:
Shut off main water supply before installing new faucet.
12 3/8"
(315mm)
5 3/4"
(147.1mm)
9 1/2"
(242.8mm)
Ø2"
(50mm)
4 5/8"
(118.7mm)
2 1/8"
(54mm)
Ø1 1/2"
(38mm)
Ø1 3/8"
(34mm)
7 1/4"
(185mm)

66
Step 1. Remove mounting hardware
Step 2. Install faucet and mounting hardware
Remove the mounting screws
(3D), mounting nut (3C), metal
washer (3B) and rubber washer
(3A) from the mounting pipe.
Insert faucet body (2) into hole in
countertop or deck plate
assembly. Install mounting
hardware (3A, B, C & D) from
underneath the countertop.
3C
3A 3B
3D
3C
3A 3B
3D

7
Step 3. Secure mounting hardware
Adjust direction of faucet body (2)
so that handle is on right side of
faucet. Tighten mounting nut (3C)
until snug. Tighten mounting
screws (3D) to nut with Phillips
screwdriver until snug.
Step 4. Connect waterlines
Connect hot and cold copper lines
(4) to angle stops. Tighten both
ends of waterlines with a wrench
until snug. Turn on hot and cold
angle stops and check for leaks.
4
NOTE: Please make sure filter
washers are installed before
connecting to the main valve.