Kraus Natura KSV-3MW User manual

www.kraususa.com I Toll Free: 1.800.775.0703 I © 2017 Kraus USA Inc. I REV. September 29, 2017
INSTALLATION MANUAL
Natura™Series White Matte
Vessel Bathroom Sink
KSV-1MW / KSV-2MW / KSV -3MW / KSV-4MW /
KSV-5MW / KSV-6MW

2
Thank you for your purchase
We would like to take this opportunity to thank you for choosing Kraus.
We hope that you are completely satised with your purchase, and enjoy it for years
to come. If you have any questions, or require technical assistance, please contact
us at 800.775.0703 and one of our representatives will be happy to help.
For more information about Kraus products, please visit:
www.kraususa.com
In order to activate your warranty and get faster access to customer support, please
register your new Kraus product at:
www.kraususa.com/registration
Sincerely,
Kraus USA Customer Service

3
Prior to Installation:
• Inspect the sink prior to installation to make sure it has not been cracked or
chipped during shipping
• Observe all plumbing and building codes according to your state requirements
• Additional oor and wall preparation may be required to avoid damaging the sink
WARNING: This product is fragile and can break, chip, or cause injury if handled
recklessly. Please consult with a professional when installing
For technical assistance or replacement parts, please contact Kraus
Customer Service and one of our representatives will be happy to help:
Toll-Free: 800-775-0703 or [e-mail]
The step-by-step guidelines in the installation instructions are a general reference for installing
a Kraus Sink. Should there be any discrepancies, Kraus cannot be held liable. It is recommended
to install all Kraus products by hiring a licensed professional.

4
Dimensions
Tools you will need:
4” Hole Saw
Safety Goggles Drill
Tape Measure
Silicone Adhesive
Pencil
Adjustable wrench Phillips screwdriver
Tools You Will Need
Hex wrenchSilicone Sealant
A
I
D
J
F
B
G
C
H
E
1.7”
15”
4.9”
1.7”
15”
4.9”
20”
1.7”
14”
4.9”
20”
1.7”
14”
4.9”
KSV-1MW
15” x 4.9”
KSV-2MW
20” x 14” x 4.9”
• Cleaning Sponge • Buffing Paper
Parts List (Included)

5
Dimensions
19.6”
1.7”
15.7”
4.3”
16.8”
1.7”
16.8”
6”
6”
16.4”
1.7”
6”
16.4”
1.7”
16.8”
1.7”
16.8”
6”
3.6”
19.6”
1.7”
15.7”
3.6”
19.6”
1.7”
15.7”
19.6”
1.7”
15.7”
4.3”
KSV-5MW
16.8” x 16.8” x 6”
KSV-3MW
19.6” x 15.7” x 4.3”
KSV-6MW
16.4” x 6”
KSV-4MW
19.6” x 15.7” x 3.6”

6
1. Mark Faucet and Drain Hole Location
• Place sink in desired location on countertop and mark drain hole and
faucet hole centerline with a pencil
NOTE: Make sure clearance is suitable for backsplash, faucet, and sink
plumbing
NOTE: Please allow a minimum of 3.5”from wall to edge of sink for faucet
placement clearance
1 1/2”
2”

7
• Place sink in desired location on countertop and mark drain hole and
faucet hole centerline with a pencil
2. Drill Countertop
• Cut the drain opening in the countertop by carefully placing the 4”
hole saw on the area marked by pencil
2”
2 1/2”
3. Apply Silicone
• Check the alignment of the sink to the opening in the countertop. Use a
bead of clear silicone (or preferred adhesive) around the underside of the sink
Clip Location
Rim of Lavatory
Cut Along This Line
11.61” (295mm)
17.7” (450mm)
Model No. KCU-251
Allow a minimum of 4.5” (114.3mm)
from wall for faucet placement
clearance before cutting
NOTE: When plotting template
full size: Make sure horizontal
and vertical dimensions match
the dimensions labeled in the
template
12.9” (328mm)
19.9” (506mm)
Clip Location
Rim of Lavatory
Cut Along This Line

8
4. Install Sink
4. Install Plumbing Fixtures
• Connect drain to sink. Connect trap to drain. Connect water supply
connections to faucet according to manufacturer’s instructions
• Run water into sink and check for leaks
• Carefully place the sink on the countertop, align, and press rmly
• Allow sealant to set for 30 – 60 minutes
NOTE: Use acetone or rubbing alcohol to remove any excess sealant
immediately after application

9
Codes/Standards Applicable:
BATHROOM SINK WARRANTY
Kraus products are manufactured and tested to the highest quality standards by Kraus USA Inc. (“Kraus”).
Kraus extends this warranty to the original purchaser for personal household use of the “Solid Surface Sink” in its
original location. The warranty is non-transferable.
Kraus warrants the structure and nish of the product (Solid Surface Sink) to be free from defects in material and
workmanship under normal usage for the lifetime of the product. The warranty commences from the initial date of
purchase by the owner or trade professional, from an authorized Kraus dealer, through the lifetime of the original owner
or end-user.
Any product reported to the authorized dealer or to Kraus as being defective within the warranty period will be repaired
or replaced with a product of equal value at the option of Kraus. This warranty extends to the original owner or end-user,
and is not transferable to a subsequent owner.
RESTRICTIONS
This warranty does not cover antediluvian, discontinued, or display products, whether such items are purchased at
discount outlets, unauthorized dealers, and/or sold on clearance.
This warranty does not cover instances of negligence, misuse, abuse, improper installation, carelessness, accident, hard
water or mineral deposits, exposure to corrosive materials, misapplication, damages caused by improper maintenance,
alteration of the product, or failure to follow care or installation instructions enclosed with your product. Avoid using
abrasive cleaners such as powders, bleach, ammonia, alcohol, or chlorine. Avoid using abrasive pads, steel wool, or wire
brushes, as these will damage and wear down the nish.
This warranty does not apply to Products that have not been installed or operated in accordance with instructions
supplied by Kraus and all applicable rules, regulations, and legislation pertaining to such installations.
This warranty does not apply unless the Kraus product is installed by a fully insured and licensed trade professional.
Kraus insists that such professionals have experience in the installation of bathroom and kitchen manufactured goods.
This warranty does not cover labor charges or costs of removal and reinstallation of said product. This warranty does
not allow recovery of incidental or consequential damages, such as loss of use, delay, property damage, or other
consequential damages, and Kraus accepts no liability for such damages.
Due to the nature of drain usage, there is no nish warranty on any drain product (including pop-up drains,
lavatory drains, and kitchen drains)
This warranty does not cover Marine or Outdoor Installation.
Except as otherwise provided above, Kraus makes no warranties, expressed or implied, including warranties of
merchantability and tness for a particular purpose, or compliance with any code.
Shipping charges will be covered for the rst (1) year of the warranted replacement part or product (HI, AK, and and
Puerto Rico shipping charges may apply). International shipping fees are not included.

10
COMMERCIAL WARRANTY
Kraus extends the above warranty for a period of one (1) year to purchasers of products for industrial, commercial, and
business use.
All incidental or consequential damages are specically excluded. No additional warranties, express or implied are given,
including but not limited to, any implied warranty of merchantability or tness for a particular purpose.
Some states do not allow the exclusion or limitation of incidental or consequential damages, or limitations on how long
an implied warranty lasts, so the above limitations or exclusions may not apply to you.
This warranty gives you specic legal rights, and you may also have other rights which vary from state to state.
If you are a homeowner please contact a Kraus Customer Service Representative at:
Kraus USA, Inc.
12 Harbor Park Drive
Port Washington, NY 11050
Toll-free 800-775-0703
[email protected]
If you are a plumbing contractor or trade professional please contact a Kraus
Pro Representative at:
Kraus USA, Inc.
12 Harbor Park Drive
Port Washington, NY 11050
516-801-8955
[email protected]
If you are an Authorized Partner please contact a Partner Support Representative at:
Kraus USA, Inc.
12 Harbor Park Drive
Port Washington, NY 11050
516-801-8954
[e-mail]
In requesting warranty service, please be ready to provide:
1. Proof of purchase
2. A description of the problem
Download the Kraus Care & Maintenance Guide at:
http://www.kraususa.com/maintenance