Kraus Viva Series User manual

VivaTM Series Ceramic
Vessel Bathroom Sink
KCV-200 / KCV-201 / KCV-202 /
KCV-203 / KCV-204 / KCV-205

Prior to Installation:
·Inspect the sink prior to installation to make sure that it has not been cracked
or chipped during shipping
·Observe all plumbing and building codes according to your state
requirements
·Additional floor and wall preparation may be required to avoid damaging the
sink
WARNING: This product is fragile and can break, chip or cause injury if handled
recklessly. Please consult with a professional when installing
3
The step-by-step guidelines in the installation instructions are a general reference for
installing a Kraus Sink. Should there be any discrepancies, Kraus cannot be held liable. It
is recommended to install all Kraus products by hiring a licensed professional.

Tools you will need:
4
KCV-200
16 1/2" x 5 1/2"
Ø 16 1/2" Ø 15 3/4"
Safety Goggles Drill Silicone Adhesive 4" Hole Saw
Pencil Tape Measure
Dimensions
KCV-201
15 3/4" x 4 3/4"
5 1/2"
1 3/4"
4 3/4"
1 3/4"

5
15 5/8"
15 5/8"
5 1/8"
Ø 16 1/2"
Ø 15 3/4"
Ø 13"
Dimensions
KCV-202
15 5/8" x 15 5/8" x 5 1/8"
KCV-203
16 1/2" x 4 3/8"
KCV-204
13" x 4 3/8"
KCV-205
15 3/4" x 5 3/8"
1 3/4"
4 3/8"
1 3/4"
4 3/8"
1 3/4"
1 3/4"
5 3/8"

6
1. Mark Faucet and Drain Hole Location
·Place sink in desired location on countertop and mark drain hole
and faucet hole centerline with a pencil.
NOTE: Make sure clearance is suitable for backsplash, faucet and sink
plumbing
NOTE: Please allow a minimum of 3 1/2" from wall to edge of sink for faucet
placement clearance
2"
1 1/2"

7
2. Drill Countertop
·Cut the drain opening in the countertop by carefully placing the 4"
hole saw on the area marked by pencil.
3. Apply Silicone
·Check the alignment of the sink to the opening in the countertop. Use a
bead of clear silicone (or preferred adhesive) around the underside of
the sink.

8
4. Install Sink
·Carefully place the sink on the countertop, align and press firmly
·Allow sealant to set for 30 - 60 minutes
NOTE: Use acetone or rubbing alcohol to remove any excess sealant
immediately after application
5. Install Plumbing Fixtures
·Connect drain to sink. Connect trap to drain. Connect water supply
connections to faucet according to manufacturer's instructions
·Run water into sink and check for leaks
Codes/Standards Applicable: