Kustom Signals Ontario Falcon HR User manual

The Falcon HR is capable of operating in the following modes:
Stationary ALL
Operation while the patrol vehicle is parked. Capable of
capturing speed data from vehicles that are approaching
and receding.
Stationary
Approaching Only
Operation while the patrol vehicle is parked. Capable of
capturing speed data from vehicles that are approaching
only.
Stationary
Receding Only
Operation while the patrol vehicle is parked. Capable of
capturing speed data from vehicles that are receding only.
Automatic
Self Test
Falcon HR performs an internal accuracy test every five (5)
minutes.
Manual Self Test
Press the Test button to run internal accuracy tests.
9652 Loiret Boulevard, Lenexa, KS 66219-2406
[phone] [phone]
www.kustomsignals.com KSI Part # 006-1075-01 Rev. 1
Ontario Falcon HR Quick Start Guide
Display Graphic
www.kustomsignals.com
[phone] [phone]
1 Get To Know The Falcon HR
6Falcon HR Operating Modes
7Accuracy Tests
Test/Batt/Hold
indicator
Strongest target
Fast/Lock label
Mode label
Fastest direction
indicator
Approaching vehicle
indicator
Receding vehicle
indicator
Fastest/locked
speed
Target speed
Transmitter/
Receiver
Handle
Display
Control buttons
Infrared remote
detector
Handle/pod
latch

Button
Function
Used to turn the Falcon HR on and off.
Used to place the Falcon HR in the Range Set “rnG” mode.
A secondary function is the incremental up control for audio and
range.
Used to place the Falcon HR in the Audio Set mode.
A secondary function is the incremental down control for audio
and range.
Used to navigate through the operational mode loop. The
available selections are Stationary “ALL” mode, Stationary
Approaching only “APr”, and Stationary Receding only “rEc”.
Initiates the internal self-test to test the internal accuracy and
illumination of all display indicators.
+
Pressing and releasing the Test button followed by pressing
and releasing the Mode button will toggle on and off the
backlight.
+
Pressing and releasing the Aud button followed by pressing and
releasing the Mode button will toggle on and off the audio
Doppler squelch.
Automatic unlocking
of locked speeds
The Falcon HR defaults to not automatically unlocking
speeds the officer has locked. If automatic unlocking is
required, add 1 to the Options total.
Track through lock
(trigger operation)
The Falcon HR defaults to transmitting for 5 seconds
after the trigger is released when locking a target. This
allows the target to be tracked after lock during this
time. If preferred, the transmitter can be shut off
immediately upon trigger release. To select that
option, add 2 to the Options total.
2 Falcon HR Rear Panel Control Button Locations
3Falcon HR Control Button Function
Power button
Test button
Mode button
Range
sensitivity/up
button
Audio /down
button
4Optional Features