KW Cages Metro Condo 4612 User manual

Metro
Drawing is representative of most models. Some variations between models may occur.
WARNING
Wire panels and sheetmetal parts may have sharp edges,
especially when handled as loose components. Use caution
when handling or performing cage assembly and maintenance.
Always wear gloves and safety eye-protection to help reduce
the chance of personal injury.
SKU (L x W x H) Comps.
4612 30” X 24” X 34” 1
4611 36” X 24” X 34” 1
Size

Metro
Qty Description
1 Main Panel Assembly
1 Upper Level with Ramp
1 Back Panel
1 Top Panel
Layout and count all parts as shown in the assembly diagram. Notify Customer Service
immediately if any parts are missing or damage has occured during shipment.
Part List
Qty Description
4 Door Guards
1 Tray
1 Pack of Cage Clips
4 Deflectors

Unfold main panel assembly (A) secure corners
using cage clips (G) every 4 inches.
Secure front and both side deflectors (H) to the cage using cage clips at each slot.
1Attach upper level (B) halfway up the inside of the
cage using cage clips every four inches around
the perimeter.
2
Cage clip pliers are recommended for assembly.
3

© 2019 Kagewerks, Inc.Form No. 921 - Rev. 9/19
Snap door guards (E) around the door
opening. Slide tray (F) into open slot at the bottom of
the cage.
5
6
Attach back panel (C) to main panel assembly
using cage clips every four inches where the
panels meet. Secure back deflector now that
back panel is secured to the cage.
4
Attach top panel (D) to back edge of cage using cage
clips.
7