KW Cages Pro Pig 3952 User manual

Pro
Drawing is representative of most models. Some variations between models may occur.
WARNING
Wire panels and sheetmetal parts may have sharp edges,
especially when handled as loose components. Use caution
when handling or performing cage assembly and maintenance.
Always wear gloves and safety eye-protection to help reduce
the chance of personal injury.
SKU (L x W x H) Comps.
3952 24” X 24” X 12” 1
3950 30” X 24” X 12” 2
3953 36” X 24” X 12” 2
Size

Pro
Qty Description
1 Sub-Assembled Cage Body
Opt. Bedding Guard Set (Sold Seperately)
1 Sub-Assembled Top/Front Panel
4-8 Door Guard Set (4 per compartment)
Layout and count all parts as shown in the assembly diagram. Notify Customer Service
immediately if any parts are missing or damage has occured during shipment.
Part List
Qty Description
1 Sliding Tray [2x (3950 & 3953)]
Opt. Leg Base Kit (Sold Seperately)
Opt. Floor Stiffener
1 Pack of Cage Clips

Swing sub-assembled cage body (A) upward
and attach sides to back panel using cage
clips (H) every three inches.
1Optional: If bedding guards were ordered.
Attach deflectors (B) to cage using cage
clips at each slot.
2
Attach sub-assembled top/front panel (C)
to side panels using cage clips every three
inches.
4
Cage clip pliers are recommended for assembly.
5
Snap door guards (D) around edges of
door opening. Repeat steps for both door
openings.

7Align tabs on leg supports (F) so that they straddle the ver-
tical wire on cage that is 1” from cage corner. Leg tabs t
over horizontal bars of cage as shown. Top tabs should slide
into horizontal wire on side panel. Using pliers, squeeze top
tabs to secure legs in place. Cages can be stacked up to four
levels high.
Attach floor stiffener (G) to front of flooring by sliding it over
edge of wire until it is in place.
Note: Floor stiffener is included with leg base kit and is only
necessary on the bottom cage when stacking multiple units.
Insert sliding trays (E) into opening below wire
flooring. Cage is now ready for use.
8
6
Leg Base Kit Option (Sold Seperately)
Required to raise the bottom of the cage off the ground.
Optional

Caster Kit Option (Sold Seperately)
Allows units to be moved easily. Must be used with support shelf.
Support Shelf Option (Sold Seperately)
Recommended when adding casters to stcked cages for extra
stability. Also allows for easily accessible storage.
1
2
3
Insert threaded bolt (B) through pre drilled
holes on stem of caster wheel (A).
Tighten locking nut (C) on back side of leg
support using 7/16” wrench
For stability be sure caster stems are tightly
fastened to cage leg and in a vertical position.
Note: Leg extensions must not be used with
caster kits.
1With support shelf (A) lip facing downward,
align holes with upper holes on leg support
(B).
2
Insert screw (C) and tighten locking nut
(D) securely, using a screwdriver and 7/16”
wrench. Repeat steps to attach each leg to
support shelf.
Optional

Stacking
The ProPig Series can be stacked up to four units tall for a total height of 61 inches.
1Align second level cage over bottom cage and set in place. Use cage
rings and cage ring pliers (sold seperately) to secure cages together
at corners and at center of each side. Repeat steps with the third and
fourth level to create a stacked unit.
© 2019 Kagewerks, Inc.Form No. 907 - Rev. 6/19