KW Cages Show-N-Go 8095 User manual

Show- -Go
Drawing is representative of most models. Some variations between models may occur.
WARNING
Wire panels and sheetmetal parts may have sharp edges,
especially when handled as loose components. Use caution
when handling or performing cage assembly and maintenance.
Always wear gloves and safety eye-protection to help reduce
the chance of personal injury.
SKU (L x W x H) Comps.
8095 33” X 20” X 12” 4
Size

Show- -Go
Qty Description
1 Main Panel Sub Assembly
2 Solid Partition
1 Floor
1 Hay Feeder
Layout and count all parts as shown in the assembly diagram. Notify Customer Service
immediately if any parts are missing or damage has occured during shipment.
Part List
Qty Description
16 Door Guards
1 Transport Tray
1 Pack of Cage Clips

Unfold main panel sub assembly
(A) so that each side panel meet
at the corners. See diagram ^
1Attach front, back and side pan-
els using cage clips (G) every
two inches.
2
3
4
Cage clip pliers are recommended for assembly.
5
Attach flooring (C) to cage, one inch up from
the bottom of side panels using cage clips
every two inches.
Attach left partition to left and top panel using
cage clips or rings at each slot. Repeat step for
right partition.
Position left and right parti-
tion (B) centered from front
to back using one cage clip at
each slot.

7
© 2019 Kagewerks, Inc.Form No. 908 - Rev. 4/19
Attach hay feeder (D) to top of cage using
cage clips every two inches. Note: Hay
feeder should sit flush in the “V” shape
area between the two solid partitions.
6
Position cage so that it sits inside tray (F)
once asssembly is completed.
8
6
Using spring hook, attach cage to secure the
tray during transport.
Snap door guards (E) around edges of door opening.
Repeat steps for all four doors.