/ BEFORE YOU BEGIN /
1
, ,
.
() .
- ,
ysh
.
.
1:1,
.
-
,
.
- ,
!
Before assembling, please read the following carefully:
●First, read this instruction manual and understand the models con--
struction.
●Check the contents of this kit.
Should parts be missing, immediately contact the retail shop or your nearest
Kyosho distributor.
●Do not take the wrong screw or small part. Compare it to the true-to-
scale dia-gram in each assembly step, then install it.
●When tightening a self-tapping (TP) screw:
Even if feeling hard, tighten a TP screw until the part will be securely
attached. However, do not overtighten it as the plastic thread inside the part
may strip!
:
How to read the instruction manual:
3
No.4, No.5, No.6
-
Metal Bushing
4
King Pin
4
6
4
5
5
7
5
Front Suspension
1
〔説明例Example〕
A:
.
B:
,
1:1.
C: ,
,
.
.
.
D:
. ,
-
.
A: Indicates the number of the assembly step
and the part that will be assembled.
B: Key Number, Part Name, True-to-scale
Diagram, Quantity Used.
C: All parts except screws are identified by key
numbers. For purchasing spare parts, find
the key number of the part needed in the
spare parts list and refer to the left column
to look up the corresponding order number.
D: This instruction manual uses several
symbols. Please note them during the
entire assembly at the bottom of each page.
A
C
C D
D
B
5 x 10mm
Correct
Wrong
4 ©1999-2007, HobbyCenter.Ru
.
. 1:1, .
( ).
This kit contains screws and hardware in different metric sizes and shapes.
Before using them, check the screws on the true-to-scale diagrams on the left side in each assembly step. Some screws are extras.
2
●ビ SCREWS
ビス Screw
-
Cap Screw
F/H Screw
-
Self-tapping (TP) Screw
-
TP F/H Screw
()
Set Screw
OTHER HARDWARE
3x12
Screw
3mm
12mm
3mm
12mm
Flat Head (F/H) Screw
Washer ・Nut
3mm
5 -
Metal Bushing・Bearing
5mm
10mm
3mm
- -
E-ring
6
Pillow Ball
6.8mm
