LAZBOY Bristol Woven User manual

Bristol Woven Coffee Table
Owner’s Manual
If you have any problems with this product, DO NOT RETURN IT TO THE
STORE. CALL OUR CUSTOMER SERVICE HOT-LINE AT
855-561-6913
8AM-5PM (EST), Monday – Thursday
8AM-4PM (EST), Friday
La-Z-Boy® is a registered trademark of La-Z-Boy Incorporated and is used under
license to BJI, Inc. © 2017 La-Z-Boy Incorporated.

This product is not intended for commercial use and is for residential use only. All warranties are limited and apply
to the original purchase only. Proof of purchase is required.
Please visit us at www.LaZboyOutdoor.com. There you can review our full warranty details and other helpful
information. Or, you may call us at 855-561-6913, 8am-5pm (EST), Monday-Thursday, 8am-4pm (EST), Friday.
Care and Maintenance
Be careful to never allow water to build up in frames as this will cause corrosion and freeze damage in cold climates. Wash all frames
with a solution of mild soap and water. Rinse with clean water and dry with a soft absorbent cloth towel. Frames can be treated with a
liquid wax for maximum protection against UV rays and/or salty damp air. If your set includes cushions, slings, and/or an umbrella they
may be cleaned by hand with a solution of soap and water with a clean water rinse. (Never machine wash cushions, slings or umbrella
covers as this will result in shrinkage or damage).
After cleaning cushions tip on end and allow to drip dry. (Never use a commercial or home dryer to tumble dry fabric goods).
Do not use bleach or solvents to clean any product! This will void the warranty.
Lack of original receipt will void warranty!
CAUTION: Read all the instructions before assembly. Failure to do so may result in faulty assembly and potential injury!
Assemble product on a soft, non-abrasive surface such as a carpet or cardboard to avoid damaging the item. Seek assistance to
assemble bulky or heavy items. After final alignment, make sure all bolts and nuts are securely tightened with screw head covers
pressed in place.
Note: Identify all parts packed in the carton against the Parts List. Remove all of the protective material carefully, and DO
NOT use a knife in order to avoid scratching the furniture. Do not tighten the bolts until the product is completely
assembled. PARTS LIST
Part# Description Picture Qty
A Table rim 1
B Leg connector
1
C Table glass 1
D Table leg
4
E M6 Bolt 12
F M6 Washer
12
G Plastic cap
12
H M6 allen wrench 1

Assembly Steps:
Note: Do not fully tighten bolts until product is completely assembled.
Step 1. Carefully place the table rim (A) upside down on a non-abrasive surface. See Figure 1.
Step 2. Assemble the table legs (D) to the table rim (A) with bolts (E) and washers (F) by using allen wrench (H).
as shown in figure 1.
Figure 1
Step 3. Assembly the leg connector (B) to the table legs (D) with bolts (E) and washers (F) by using allen wrench (H). See
Figure 2.
Step 4. Check the alignment of all table legs (D) and adjust if necessary. Once the alignment is correct, tighten all bolts with
allen Wrench (H).
Figure 2
Step 5. Cover all bolts with plastic caps (G). See Figure 1-2.
A

Step 6. Verify all bolts are securely tightened before use and turn your table right side up.
Step 7. Place the table glass (C) on the table rim (A), See Figure 3.
Figure 3
Now your table is ready to use.
WARNING:
1. Do not crawl, stand, or sit on tabletops.
2. Do not set or lay heavy items on table tops.
3. Avoid extreme hot & cold items being placed on table tops.
This glass table top is produced with tempered glass which is designed to safely shatter in small pieces when
impacted or stressed beyond strengthlimitations.
I

Page 1 of 4
Bristol Woven Lounge
Chair Owner’s Manual
If you have any problems with this product, DO NOT RETURN IT TO THE STORE.
CALL OUR CUSTOMER SERVICE HOT-LINE AT
855-561-6913
8AM - 5PM (EST), Monday -Thursday
8AM – 4PM (EST), Friday
La-Z-Boy® is a registered trademark of La-Z-Boy Incorporated and is used under
license to BJI, Inc. © 2017 La-Z-Boy Incorporated.

Page 2 of 4
This product is not intended for commercial use and is for residential use only. All warranties are limited and apply
to the original purchase only. Proof of purchase is required.
Please visit us at www.LaZboyOutdoor.com. There you can review our full warranty details and other helpful
information. Or, you may call us at 855-561-6913, 8am-5pm (EST), Monday-Thursday, 8am-4pm (EST),Friday.
Care and Maintenance
Be careful to never allow water to build up in frames as this will cause corrosion and freeze damage in cold climates. Wash all frames
with a solution of mild soap and water. Rinse with clean water and dry with a soft absorbent cloth towel. Frames can be treated with a
liquid wax for maximum protection against UV rays and/or salty damp air. If your set includes cushions, slings, and/or an umbrella they
may be cleaned by hand with a solution of soap and water with a clean water rinse. (Never machine wash cushions, slings or umbrella
covers as this will result in shrinkage or damage).
After cleaning cushions tip on end and allow to drip dry. (Never use a commercial or home dryer to tumble dry fabric goods).
Do not use bleach or solvents to clean any product! This will void the warranty.
Lack of original receipt will void warranty!
CAUTION: Read all the instructions before assembly. Failure to do so may result in faulty assembly and potential injury!
Assemble product on a soft, non-abrasive surface such as a carpet or cardboard to avoid damaging the item. Seek assistance to
assemble bulky or heavy items. After final alignment, make sure all bolts and nuts are securely tightened with screw head covers
pressed in place.
Note: Identify all parts packed in the carton against the Parts List. Remove all the protective material carefully, and DO
NOT use a knife to avoid scratching the furniture. Do not tighten the bolts until the product is completely assembled.
PARTS LIST
Part# Description Picture Qty
A1 Right arm 1
A2 Left arm 1
B Back 1
C Seat 1
D M6 bolt
10
E M6 washer
10
F M6 bolt cap
10
G M6 allen wrench 1
H Sear cushion 1

Page 3 of 4
I Back cushion 1
J Lumbar pillow 1
Assembly Steps:
Note: Do not fully tighten bolts until product is completely assembled.
Step 1. Attach right arm (A1) and left arm (A2) into chair back (B) with M6 bolts (D) and M6 washers (E) by using allen
wrench (G). See Figure 1.
Figure 1
Step 2. Attach seat (C) to chair back (B) with M6 bolts (D), M6 washers (E) by using allen wrench (G). See Figure 2.
Figure 2
Step 3. Assembly seat (C) to right arm (A1) and left arm (A2) with M6 bolts (D) and M6 washers (E) by using allen wrench.
See Figure 3.
C

Page 4 of 4
Figure 3
Step 4.Tighten all bolts with allen wrench (G) completely, and cover them with bolt caps (F), See figure 1~3.
Step 5.Turn over the chair, and place seat cushion (H), back cushion (I) and lumbar pillow (J) in chair as shown.
See Figure 4.
Step 6. Repeat step 1,2,3, 4 and 5 for the other chair.
Figure 4
Now your lounge chair is ready for your enjoyment.

Page 1 of 4
Bristol Woven Loveseat
Owner’s Manual
If you have any problems with this product, DO NOT RETURN IT TO THE STORE.
CALL OUR CUSTOMER SERVICE HOT-LINE AT
855-561-6913
8AM-5PM (EST), Monday – Thursday
8AM-4PM (EST), Friday
La-Z-Boy® is a registered trademark of La-Z-Boy Incorporated and is used under
license to BJI, Inc. © 2017 La-Z-Boy Incorporated.

Page 2 of 4
This product is not intended for commercial use and is for residential use only. All warranties are limited and apply to the
original purchase only. Proof of purchase is required.
Please visit us at www.LaZboyOutdoor.com. There you can review our full warranty details and other helpful information.
Or, you may call us at 855-561-6913, 8am-5pm (EST), Monday-Thursday, 8am-4pm (EST),Friday.
Care and Maintenance
Be careful to never allow water to build up in frames as this will cause corrosion and freeze damage in cold climates.
Wash all frames with a solution of mild soap and water. Rinse with clean water and dry with a soft absorbent cloth towel.
Frames can be treated with a liquid wax for maximum protection against UV rays and/or salty damp air. If your set
includes cushions, slings, and/or an umbrella they may be cleaned by hand with a solution of soap and water with a clean
water rinse. (Never machine wash cushions, slings or umbrella covers as this will result in shrinkage or damage).
After cleaning cushions tip on end and allow to drip dry. (Never use a commercial or home dryer to tumble dry
fabric goods). Do not use bleach or solvents to clean any product! This will void the warranty.
Lack of original receipt will void warranty!
CAUTION: Read all the instructions before assembly. Failure to do so may result in faulty assembly and potential injury!
Assemble product on a soft, non-abrasive surface such as a carpet or cardboard to avoid damaging the item. Seek
assistance to assemble bulky or heavy items. After final alignment, make sure all bolts and nuts are securely tightened
with screw head covers pressed in place.
Note: Identify all parts packed in the carton against the Parts List. Remove all the protective material carefully, and DO
NOT use a knife to avoid scratching the furniture. Do not tighten the bolts until the product is completely assembled.
PARTS LIST
Part# Description Picture Qty
A1 Right arm 1
A2 Left arm 1
B Back 1
C Seat 1
D M6 bolt
11
E M6 washer
11
F M6 bolt cap
11
G M6 Allen wrench
1
H Seat cushion 1

Page 3 of 4
I Back cushion 2
J Toss pillow 2
Assembly Steps:
Note: Do not fully tighten bolts until product is completely assembled.
Step 1. Attach right arm (A1) and left arm (A2) into chair back (B) with bolts (D) and M6 washers (E) by using allen wrench.
See Figure 1.
Figure 1
Step 2. Attach seat (C) to chair back (B) with M6 bolts (D) and M6 washers (E) by using allen wrench. See Figure 2.
Figure 2
Step 3. Attach seat (C) to right arm (A1) and left arm (A2) with M6 bolts (D) and M6 washers (E) by using allen wrench. See
Figure 3.
C

Page 4 of 4
Figure 3
Step 4. Tighten all bolts with allen wrench (G) completely, and cover them with bolt caps (F), See figure 1- 3.
Step 5. Turn over the chair, and place seat cushion (H), back cushion (I) and toss pillow (J) in chair as shown.
See Figure 4.
Figure 4
Now your loveseat is ready for your enjoyment.